Classe Audio CAP-2100 owner manual AC Mains Fuse, AC Mains Power Switch

Important!

Danger!

12AC Mains Fuse

An AC mains fuse holder is located next to the AC mains input. It is unlikely that you should ever have to replace this fuse, but if you do, it is critical that you do so only with a fuse of exactly the same rating and value (specified in Troubleshooting #8).

Never replace a blown fuse on this or any other piece of electronics with anything other than a fuse of exactly the same rating and value. Doing so can cause damage to your electronics that may not be covered by the warranty.

Always disconnect the integrated amplifier from the AC mains and from the speakers before attempting to replace a fuse. If the fuse blows again upon powering back up, contact your authorized Classé dealer for assistance.

There are no user-serviceable parts inside the CAP-2100.

13AC Mains Input

An IEC standard power cord (supplied) is used with the CAP-2100. Plug the cord into the IEC receptacle provided, and the other end into a suitable wall outlet.

14AC Mains Power Switch

The main power switch for the CAP-2100 is located near the middle of the rear panel, beside the receptacle for the power cord.

The integrated amplifier should be in standby before being switched off. Switching the unit on puts it in standby mode.

Potentially dangerous voltages and current capabilities exist within your integrated amplifier, even when disconnected from AC mains. Do not attempt to open any portion of the integrated amplifier’s cabinet. There are no user-serviceable parts inside your integrated amplifier. All service of this product must be referred to a qualified authorized Classé dealer or distributor.

19