GB
USER INSTRUCTIONS
Classic smart 1F Universal Remote Control
INSERTING THE BATTERIES
Your new smart 1F remote control uses 2 LR03 or AAA Alkaline batteries which must be installed before it can be used. Always use new batteries of the same type and install the two new batteries the correct way round as shown by the battery markings in the battery compartment on the back of the remote control. Please dispose of used batteries as advised by the battery manufacturer.
SETTING UP YOUR smart 1F
Your smart 1F can control TV basic functions incl. Teletext.
It can be set up by entering either a 3 digit code from the code list included in your instruction book or by using the library search facility. Instructions for both methods follow.
SET UP BY ENTERING A 3 DIGIT DEVICE CODE
Refer to the code list in your instruction book and look up the 3 digit code which corresponds to the brand of TV you wish to control.
If there is more than one code listed against the brand start with the first code.
Make a note of the code and follow steps 1) to 5) below.
1)Switch on the TV you wish to control.
2)Press and hold down the STANDBY key on the smart 1F and at the same time press and hold down the OK key. Keep both keys pressed down for approximately 5 seconds until the indicator light on the STANDBY key being held down lights and remains on. Release both keys.
3)Use the number keys on the handset to enter the 3 digit code you found in the code list.
4)Press and release the STANDBY key and the indicator will blink 3 times. This indicates that you have now stored the code into the handset.
5)Try all of the functions of the remote control.
6)If your device does not respond or responds incorrectly to the commands repeat steps 1) to 5) using the next number you found against your brand in the code list.
If the STANDBY key does not blink 3 times at step 4 an incorrect code has been entered. Check for the correct 3 digit code for your TV in the code table and repeat steps 1) to 5).
Make a note of the code used on the label inside the battery compartment for future use.
5
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
smart1F.indd 5 |
|
| 01.10.2008 10:20:29 Uhr | ||||
