Cleveland Range manual CSTK-610CA, Gas Connection, Water Connections, Drain Connection

™

Cleveland

COMBI OVEN-STEAMER

Stacking Kits for Gas Table Type Models

(OGB 6.10 on OGB 6.10 or OGS 6.10 on OGS 6.10)

Project ________________________________

Item __________________________________

Quantity _______________________________

FCSI Section ____________________________

Approval _______________________________

Date __________________________________

	Model #	Description
	CSTK-610	for mounting two 6.10 models
byCleveland	CSTK-610CA	for mounting two 6.10 models (with casters)

LEFT SIDE VIEW

36.70"

39.21"

UNIT A

G	D	W1 W2	RC	CS
		UNIT B

HOOD REQUIREMENT)
	67.85"
78.00”(MIN.

38.08"

2.52"

28.43

5.00"

28.43

1.58"	1.82"
	UNIT A

4.38"

6.00"

G D W1 W2 RC CS

NOTE: Overall height of unit does not change for units with casters.

UTILITIES (Utility connection shown below are listed per unit)

Required Clearances: Rear - 2", Left Side - 4", Right Side - 2 1/2"

•Allow for sufficient distance if a "high heat source" (i.e. Broiler) is located next to the unit.

•Allow for sufficient clearance on left side for service access (contact the factory service department for recommendations).

•Installation must comply with all local fire and health codes.

	Electrical Requirements:	120 volt, 60 Hz, single phase, UNIT A - 11.7 amps
	Do not connect to a G.F.I. outlet.		UNIT B - 11.7 amps
G	Gas Connection:	3/4" NPT
	Gas Type:	Natural Gas (Propane optional)
	Gas Flow Pressure:	Natural Gas - Min. 5.5" WC / Max. 14" WC
		Propane Gas - Min. 11" WC / Max. 14" WC
	BOILER MODELS	UNIT A - OGB-6.10	UNIT B - OGB-6.10
	Total Connected Load:	45.400 BTU	45.400 BTU
	Steam Generator:	45.400 BTU	45.400 BTU
	Hot Air:	45.400 BTU	45.400 BTU
	BOILERLESS MODELS	UNIT A - OGS-6.10	UNIT B - OGS-6.10
	Total Connected Load:	45.400 BTU	45.400 BTU
	Hot Air:	45.400 BTU	45.400 BTU

	Water Connections:	Cold Water (drinking water quality)
	Flow Pressure:	30 - 60 PSI
	Water Inlets:	3/4" GHT-F (Female Garden Hose Connection)
	W1	Treated Water for Steam Generator
	W2	Untreated Water for Condenser
D Drain Connection:		2" Tube
	Venting:	Exhaust Hood required

CS *Connection for Cleaning Solution

RC *Connection for Rinse Cycle

*Available as an option

Note: For additional connection details, see spec sheet for each individual combi model to be stacked.

SECT. IIB PAGE 5A 0707

1333 East 179 St.,	Tel: 1-216-481-4900	Web Site: www.ClevelandRange.com
Cleveland, Ohio, U.S.A. 44110	Fax: 1-216-481-3782	Email: Steam@ClevelandRange.com