CMA Dishmachines owner manual EAH/EC Options, Door Handle Conversion EAH To EC #00617.30

Title	Installation & Operation	Rev 1.00A
Model	EAH / EC Dishwasher	01/26/04

EAH/EC Options

Door Handle Conversion EAH To EC #00617.30

ITEM NO.

NO REQ’

11

21

2A 1

31

49

59

61

72

88

91

10 1

11 1

P/N DESCRIPTION

00613.04 Door Handle

00619.34 Door Hdl. Mtng. Plate-Long

00619.44 Door Hdl. Mtng. Plate-Short

00603.04 Door Spring Extension

00913.00 5/16” – 18” Nut

00926.00 5/16” SS washer

00900.00 Cotter Pin

00607.04 Door Handle Cap 1”

00920.00 5/16”-18 x ¾” Hex Head Bolt

00563.20 Roller Switch Bracket

00606.83 Eye Bolt

01505.04 Tray Track (c)

Note: Door handle mounting plates come in two sizes.

INSTRUCTIONS:Longer is mounted on back-right side.

Before handle conversion, place template with the upper edge against two upper left front panel holes. Mark the four holes position using a center punch. Drill a 1/8” hole through each position, and then drill it out to 3/8”.

1.Open dishmachine door to its highest position so that there is little spring resistance on the door handle. Remove hardware that holds the door handle to the door linkage. Save all the washers and spacers. Swing the door handle towards the back of the dishmachine and dismount it from the door handle support brackets. Remove the nut attaching the eyebolt and save the door springs.

2.Remove the two (2) door-handle support brackets on the back of the cabinet and plug the four holes with original hardware. Unscrew the 8 nuts holding the front panel and remove front panel. Remove door guides on left side of machine and mount them on the front of the cabinet. Remove tray track inline AH and replace it with the tray track (C) from the kit. Slide the left door into the door guides and mount the door linkage back on.

3.With left door facing the front, door panel on the left we are now ready to install the door handle.

4.Using provided door handle, door handle mounting plates, 5/16” bolts, nuts and washers; install the door handle as shown in “Illustrations”. Match the mounting plate holes and roller switch bracket holes to the cabinet holes and insert all bolts to ensure that the door handle and mounting plates are aligned. Then secure the mounting plate and roller switch bracket with nuts and washers.

5.Attach the provided extension rod to the back of the door handle. Attach one eyebolt to the frame with existing hardware, along with two springs together. Pivot the door handle, positioning handle straight up. You may now connect loop of 2nd spring to the door extension rod. Pull handles forward and down and attach to the door links.

6.Adjust the nut on the eyebolt until the doors begin to lift then back off two turns. See “Illustration” for proper location of all door handle hardware included on EC machine.

Page 16