Cobra Digital MT-900 manual Features of This Product, Product Information, Recharging Batteries

F E AT U R E S

Features of This Product

•TWO-WAY RADIO with up to a 3 km (2 mile) range

•8 MAIN CHANNELS*

•38 CTCSS privacy codes

•BACKLIT LCD display

•WATER RESISTANT

•BATTERY SAVER circuitry

•MAXIMUM RANGE Extender

•VOX mode for hands-free transmissions

•PRIVATE CALL voice scrambling

•VIBRALERT™

•INTERCOM capability

•10 MEMORY locations

•MEMORY SCAN

•FULL CHANNEL/CTCSS Privacy Codes scan

•CALL ALERT

•DUAL WATCH programmable 2-channel scan

•LOCK key

•AUTO SQUELCH

•5 CALL SIGNAL selections

•On/off “ROGER BEEP” confirmation tone

•On/off KEYSTROKE tones

•EXTERNAL SPEAKER/MICROPHONE jack

•BELT CLIP

•WRIST STRAP

•RECHARGING PADS

•RAPID Desktop CHARGER

•RECHARGEABLE NiMH BATTERY Pack

•AC ADAPTOR (220V, 2-Pin Euro Plug)

•PLUG CONVERTER 220V, 2-Pin Euro Plug to 240V, 3-Pin UK Plug

Product Information

This Cobra® microTALK® radio has been manufactured to meet all required standards for radio equipment using PMR 446 frequencies as authorized. The use of this 2-way radio product involves the public airways and its use may be subject to local laws or regulations. Contact your radio licensing authority for more information.

Caring for Your microTALK® Radio

Your microTALK® radio will give you years of trouble-free service if cared for properly. Here are a few suggestions:

•Handle the radio gently.

•Keep it away from dust.

•Never put the radio in water or in a damp place.

•Avoid exposure to extreme temperatures.

Recharging Batteries

You should fully recharge the battery pack before using your microTALK® for the first time.

1.Attach the power supply

to the charger base and plug
it in to an electrical outlet.
(A UK-compatible connector
is included, if required.)
Place the radio in the charger
base to begin charging.	CHARGE

2.With the optional adapter, you can place the

battery pack alone in the charger base. Pull down the LOCK TAB and remove the battery compartment cover. Remove the battery pack

and place the battery pack in the charging well.

3.The CHARGE light on the

charger base will indicate
when the battery is fully	CHARGE

charged. The light will remain

lit until the battery pack is approximately 90% charged, then blink rapidly until the battery is fully charged, then blink slowly indicating trickle charge. A full charge will take approximately 2 hours. You can leave the unit in trickle charge indefinitely.

4.Your microTALK® can also be operated with four

standard AAA alkaline batteries.

*You are not allowed to use channels 1 and 2 in France. This situation can change; please contact the French radio licensing authority for more information.