5 |
6 |
1
3 2
USING THE MEMORY
DIALING FEATURE
Memory dialing lets you store and dial 32
To Store A Number In Memory Using the Base Keypad:
In order to accomodate 32 numbers, your memory system is designed with 16 buttons which control both upper
To program numbers into the memory bank from the base:
1
1. Make sure the LED for the bank you
SWITCH want (“Upper” or “Lower”) is lit. If
BUTTON
not, press the button next to the
2“Lower” LED until the correct LED
lights.
LOWER
LED 2. Press the button for the memory location you wish to program. You
3will hear a beep and the LED will
positions. Be sure to note the names for each number you are storing, so you can create your directory card when you are finished.
To Store A Number
Longer Than 16 Digits
For telephone banking or alternate long distance service, you may need to program a number that is longer than 16 digits. To do so, you will need to divide the number between two different memory locations. Example: Store an alternate long distance acces number in location 1 and personal identification number for that service in location 2.
Creating A Directory
As you are programming the memory bank, you will want to keep track of whose number you are assigning to each location. When finished, you may indicate who is assigned to each number by filling in the directory located on the base. This provides a quick and easy reference. To create the directory, remove the protective plastic cover by sliding it gently toward the middle and lifting it out. Fill in the names on the directory next to the number they have been assigned and replace the cover.
To Dial A Number Stored In Memory From Base Keypad
when your call goes through for
To Dial A Number Stored In Memory From the Handset
5If you are away from the base where the written directory is stored, you will
TALK | have to remember the directory storage |
| |
| number for the call you wish to make. |
61. Press TALK for dial tone. MEMORY 2. Press MEMORY button.
3.Enter the directory storage number
To Replace Or Change A Number Stored In Memory
Simply repeat the steps under “To Store A Number In Memory”.The new number will automatically replace the previous number stored. Be sure the red LED indicator is set on the correct memory bank.
Permanent Memory Circuit
Your Cobra Intenna provides you with a permanent memory circuit; even if you
11
UPPER
flash to let you know it is ready to
Using Speakerphone
disconnect the AC power or experience a
Cobra®
LEDstore a number. You have 10 seconds to begin programming the number (if 10 seconds elapses without digits being entered, the LED will stop flashing, you will hear a long beep and the LED will light steadily again).
3.Enter the number you wish to store (up to 16 digits).
4.Press the same memory button again. You will hear two double beeps to confirm the number is stored. If you hear three beeps instead, you may have pressed the incorrect storage button, and you’ll need to repeat the steps above.
5.Repeat the above steps for up to 32
11. Be sure the proper memory bank is
in use (LED is lit) for the call you wish to place. If not, press the button next to “Lower” LED until either “Upper”
2or “Lower” LED is lit.
2. Press SPEAKERPHONE button to get a dial tone. Speakerphone LED lights to tell you the speakerphone is
3in use.
3. Press the storage button next to the name of the location you wish to call. The number is dialed automatically.
4You may continue using speakerphone
SPEAKER-
PHONE
power outage, don’t
NEED HELP?
