![](/images/new-backgrounds/1310439/31043927x1.webp)
Operation
Mode Functions
|
|
|
|
|
|
| Introduction | Operation | Customer Assistance | Warranty |
|
During memory location scan (while receiving an Incoming transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on that
VibrAlert and Call Alert
•
Your microTALK radio can alert you to incoming signals by sounding an audible call tone, by vibrating silently or both.
memory location.
b. Your radio will remain on that memory location and return to Standby mode. Press the Channel Up or ChannelDown button to resume scanning memory locations.
c. After 10 seconds of inactivity, unit starts scan again.
If you press the Talk button while scanning, but more than
10 seconds after receiving a transmission, you will transmit on the memory location on which, during scanning, you last received a transmission.
If you do not press any button within 10 seconds, your radio will automatically resume scanning memory locations.
Mode Button
Channel Buttons
To change call settings:
1.Press the Mode button until the Call Setting icon flashes on the display. The current setting (“01” vibrate + ring, “02” vibrate only or “03” ring only)
is displayed.
2.Press the ChannelUp or ChannelDown button to change the call setting.
3.Choose one of the following:
VibrAlert + Ring
VibrAlert Only
Ring Only
During memory location scan (while not receiving a transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on the channel/privacy code that was displayed before you entered mode functions or memory location on which, during scanning, you last received a transmission.
b. Press the Mode button to proceed to other functions.
c. Press the Lock/Enter button to return to Standby mode on the channel/privacy code that was displayed before you entered mode functions or the memory location on which, during scanning, you last received a transmission.
To reduce the number of memory locations being scanned, you may
a. Press the Mode button to enter the new setting
and proceed to other functions.
b. Press the Lock/Enter button to enter the new setting and return to Standby mode.
22 | 23 |