![](/images/new-backgrounds/1309464/30946427x1.webp)
Mode Functions
Operation
Memory Location Scan
•
Your microTALK® radio can automatically scan up to 10 programmed Memory Locations.
If there are one or fewer memory locations programmed in your radio, the scan memory locations option will not be available. To program at least two (2) memory locations, see program memory locations on page 14.
|
|
|
|
|
|
| Introduction | Operation | Customer Assistance | Warranty |
|
During memory location scan (while receiving an Incoming transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on that memory location.
b. Your radio will remain on that memory location and return to Standby mode. Press the Channel Up or Channel Down button to resume scanning memory locations.
c. After 10 seconds of inactivity, unit starts scan again.
Mode Button
Scanning Locations
Channel Button
To scan memory locations:
1.Press the Mode button until the Scan icon, Memory icon and the memory location number flash on the display.
2.Press the Channel Up or Channel Down button to begin scanning memory locations.
The Scan icon and the Memory icon will continue to be displayed when memory location scan is on. Your radio will continue to scan memory locations and stop if an incoming transmission is detected. Your radio will remain on that memory location for 10 seconds.
While setting memory location scan, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions.
If you press the Talk button while scanning, but more than
10 seconds after receiving a transmission, you will transmit on the memory location on which, during scanning, you last received a transmission.
If you do not press any button within 10 seconds, your radio will automatically resume scanning memory locations.
During memory location scan (while not receiving a transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on the channel/privacy code that was displayed before you entered mode functions or memory location on which, during scanning, you last received a transmission.
b. Press the Mode button to proceed to other functions.
c. Press the Lock/Enter button to return to Standby mode on the channel/privacy code that was displayed before you entered mode functions or the memory location on which, during scanning, you last received a transmission.
To reduce the number of memory locations being scanned, you may
22
23