Operation | Using Your Radio |
| |
|
| ||
Speaker/Microphone/Charge Jack | • | ||
Speaker/Microphone/ To attach a speaker/microphone: | |||
| |||
Charge Jack | 1. Open the speaker/microphone/charge |
| |
|
| ||
| tab on top of your microTALK® radio. |
| |
| 2. Insert the speaker/microphone accessory |
| |
| plug into the speaker/microphone/charge jack. |
| |
To connect a wall charger/adapter:
1.Open the speaker/microphone/charge tab on top of your microTALK® radio.
2.Insert the wall charger/adapter plug
into the speaker/microphone/charge jack.
Quick Start
1. Press and hold the Mode/Power button to turn on your radio.
2.Press the Channel Up or Channel Down button to select a channel.
Both radios must be tuned to the same channel/privacy code to communicate.
3.Press and hold the Talk button while speaking into the microphone.
4.When finished talking, release the Talk button and listen for a response.
Turning on Your microTALK® Radio
•
Press and hold the Mode/Power button until you
|
|
|
|
Introduction | Operation | Customer Assistance | Warranty |
Battery Low
•
Battery Low | When battery power is low, the Battery Low icon | |
will blink. Your batteries should be replaced or |
| |
|
| |
| recharged, if using rechargeable batteries. |
|
Auto Battery Save | • | |
|
| |
Battery Save Mode | If there are no transmissions within 10 seconds, | |
the radio will automatically switch to Battery |
| |
|
| |
| Save mode and the Power Saver icon will flash |
|
| in the display. This will not affect the radio’s |
|
| ability to receive incoming transmissions. |
|
Communicating with Another Person
•
Talk Button | 1. | Press and hold the Talk button. | |
2. | With the microphone about two inches | ||
| |||
|
| (5 cm) from your mouth, speak in a | |
|
| normal voice. | |
| 3. | Release the Talk button when you are | |
Two Inches (5 cm) |
| finished talking and listen for a response. | |
from Mouth | You cannot receive incoming calls while | ||
| |||
| pressing the Talk button. | ||
|
| Both radios must be tuned to the same | |
|
| channel/privacy code to communicate. | |
To Select a Channel
•
Channel Button | With the radio on, select any of the | |
22 channels by pressing the Channel Up | ||
| ||
| or Channel Down button. |
Mode/Power hear a series of audible tones indicating the radio
is on.
Your microTALK® radio is now in Standby mode, ready to receive transmissions. The radio is always in Standby mode except when the Talk, Call or Mode/Power buttons are pressed.
Channel Number |
Both radios must be tuned to the same channel/privacy code to communicate.
Channels 1 through 7 are shared with FRS/ GMRS. Channels 8 through 14 are FRS only. Channels 15 through 22 are GMRS only.
See page 14 for FRS/GMRS frequency allocations and compatibility charts.
|
|
|
|
|
2 English | Nothing Comes Close to a Cobra® 3 | |||
