Cobra Electronics CXT94 Caring for Your microTALK Radio, Rechargeable Batteries and Charger

Introduction Operation Customer Assistance Warranty

Caring for Your microTALK® Radio •

Your microTALK® radio will give you years of trouble-free service

if cared for properly. Handle the radio gently. Keep the radio away from dust. Never put the radio in water or in a damp place. Avoid exposure to extreme temperatures.

Rechargeable Batteries and Charger		•
Remove Belt Clip To install or replace batteries:
1.	Remove belt clip by releasing belt clip
	latch and sliding clip up.
2.	Pull up on the battery door latch to remove the
Pull Up Lock Latch	battery compartment cover.

Insert Batteries

Radio Charger Jack

3.Insert the supplied four AAA rechargeable batteries or non-rechargeable alkaline batteries. Position batteries according to polarity markings.

4.Replace battery compartment cover and belt clip.

To charge batteries in radio:

1.Check to see that the batteries have been inserted properly.

2.Insert the wall charger/adapter into the charge jack located at the top of the radio. The wall charger/adapter has two round connectors which enables you to charge either one or two radios at a time.

3.Plug the wall charger/adapter into electrical outlet.

It normally takes 15 hours to fully recharge batteries. It is not recommended to recharge batteries more than 24 hours. Estimated operation time on a full charge is 8 hours.

Use only the supplied rechargeable batteries and wall charger/adapter for recharging your Cobra microTALK® radio.

NOTE Do not mix old and new batteries.

Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.

Nothing Comes Close to a Cobra® 1