Cobra Electronics CXT94 owner manual Using Your Radio

Using Your Radio

Operation

Speaker/Microphone/Charge Jack			•
Speaker/Microphone To attach a speaker/microphone:
/Charge Jack	1.	Open the speaker/microphone/charge
		tab on top of your microTALK® radio.
	2.	Insert the speaker/microphone accessory
		plug into the speaker/microphone/charge jack.

To connect a wall charger/adapter:

1.Open the speaker/microphone/charge tab on top of your microTALK® radio.

2.Insert the wall charger/adapter plug

into the speaker/microphone/charge jack.

Quick Start

Introduction		Customer Assistance	Warranty
	Operation

Battery Low		•
	When battery power is low, the Battery Low icon
Battery Low
	will blink. Your batteries should be replaced or
	recharged, if using rechargeable batteries.
Auto Battery Save		•
Battery Save Mode If there are no transmissions within 10 seconds, the
	radio will automatically switch to Battery Save
	mode and the Power Saver icon will flash in the
	display. This will not affect the radio’s ability to
	receive incoming transmissions.
Communicating with Another Person		•
	1. Press and hold the Talk button.
Talk Button

1. Press and hold the Mode/Power button to turn on your radio.

2.Press the Channel Up or Channel Down button to select a channel.

Both radios must be tuned to the same channel/privacy code to communicate.

3. Press and hold the Talk button while

speaking into the microphone.

Two Inches (5 cm) from Mouth

2.With the microphone about two inches (5 cm) from your mouth, speak in a normal voice.

3.Release the Talk button when you are finished talking and listen for a response.

You cannot receive incoming calls while pressing the Talk button.

Both radios must be tuned to the same channel to communicate.

4. When finished talking, release the Talk

button and listen for a response.

Turning on Your microTALK® Radio

To Select a Channel		•
	With the radio on, select any of the
Channel Button
	22 channels by pressing the Channel Up
	or Channel Down button.

	•
Mode/Power	Press and hold the Mode/Power button until you
	hear a series of audible tones indicating the radio is
	on.

Your microTALK® radio is now in Standby mode, ready to receive transmissions. The radio is always

Channel Number

Both radios must be tuned to the same channel to communicate.

Channels 1 through 7 are shared with FRS/ GMRS. Channels 8 through 14 are FRS only. Channels 15 through 22 are GMRS only.

in Standby mode except when the Talk, Call or Mode/Power buttons are pressed.

See page 14 for FRS/GMRS frequency allocations and compatibility charts.

	Nothing Comes Close to a Cobra® 3
2