Cobra Electronics MF 2500 Mounting the Fish Finder, Installation, Installing Optional Devices

Mounting the Fish Finder

2.3.1Installation

Picture showing actual example of the MF 2500 Fish Finder installation.

Fix the MF 2500 Fish Finder to the mounting location using the four screws (holes diameter 4 mm), see previous picture.

Route the CHARTPLOTTER cable to the CobraMarineTM chartplotter. Mount the transducer according to the instructions provided with it. Connect the POWER cable to the battery. Please be advised that the MF 2500 Fish Finder when not operating will remain in Stand-By mode.

2.3.2Installing Optional Devices

See the External Connection diagram in Par. 2.5.

2.4STATUS LED

There are seven different LED behaviors, representing seven different diagnostic conditions. These are described below.

1. BOOTLOADER LED Behavior: OFF

The MF 2500 Fish Finder is running in the bootloader, or is not powered on at all.

2. STANDALONE DST, NO TRANSDUCER MODE LED Behavior: ON, steady

Nothing Comes Close to a Cobra® 9