Cobra Electronics MT 200 manual Batteries and Wall Charger, English, Antenna Belt Clip

9498 MT200-EU-British4F 4/10/06 2:38 PM Page 2

Batteries and Wall Charger

Antenna

Belt Clip

Batteries

Remove Belt Clip

Pull Latch Up

Insert Batteries

Wall Charger

To install or replace batteries:

1.Remove belt clip by releasing belt clip latch and sliding clip up.

2.Pull up on the battery door latch to remove the battery compartment cover.

3.Insert the supplied three AAA rechargeable batteries (also works with non-rechargeable alkaline bat- teries). Position batteries according to polarity markings.

4.Replace battery compartment cover and belt clip.

Battery

Compartment

Cover

Wall Charger

Radio Charger Jack To charge batteries in radio:

1.Check to see that the batteries have been inserted properly. See above for battery installation instructions.

2.Insert round connector of wall charger into the charge jack located at the top of the radio. The wall charger has two round connectors which enables you to charge either one or two radios at a time.

3.Plug the wall charger into electrical outlet.

It normally takes 15 hours to fully recharge batteries. It is not recommended to recharge batteries more than 24 hours. Estimated operation time on a full charge is 8 hours.

Use only the supplied rechargeable batteries and wall charger for recharging your Cobra microTALK® radio. Non-rechargeable alkaline batteries can also be used.

2English