COBY electronic DTV-102 specifications Remote Control Battery Installation, Power Connection

Installation

Output the TV signal from your converter box to the external receiver

You can adopt either of the methods below to output the TV signal to the external monitor. Refer to A,B in the Figure 4. for better understanding.

A. CVBS Output

Connect the video port (VIDEO) by the supplied RCA cable. (yellow plug). Connect the audio port (L, R) by the supplied RCA cable (white&red plug).

B. RF Output

Connect the RF OUT port by the RF cable to output the TV signal.

NOTE: Only two channels are available if you chose to output the signal by the RF cable.

Slide the channel switch on the unit’s rear panel to select the channel 3 or the channel 4. Left Position - - CH3 Right Position - - CH4

C. Analog pass-through Application

-Power On : User Setting the A/V and Modulator 3/4Ch Output

-Power Off : User Setting the analog pass-through Output

Installation

2.4 Remote Control Battery Installation

1.Unlatch the battery compartment cover on the back of the remote control.

2.Insert 2 AAA batteries into the battery compartment, making sure the + and – ends of each battery line up with the corresponding marks in the battery compartment, as shown in Figure 5 below.

3.Snap the cover back on to the remote control.

1) Power On Application

Analog Signal

Digital Signal

Ant In MD 3/4Ch

Composite Video Output Audio L/R

Figure 5. Install Remote Control Batteries

2.5 Initial Setup

After the input/output connections have been made, and the DTV-102 has been powered up, a blue screen should be seen on the TV screen. Pressing the MENU button on the remote control should display the main menu on the screen, as shown in Figure 6 below. Chapter 3 in this User Guide describes the procedures for basic TV operations such as scanning for channels, changing channels, language control, and information

ANT IN ANT OUT Audio-R Audio-L Video OUT

2) Power Off Application

					Receive the Analog Signal
Analog Signal
Digital Signal	Ant In			Loop-through
				Signal
		ANT IN	ANT OUT		Audio-R Audio-L Video OUT

Power Connection

Insert the power plug into the wall outlet with AC100V-240V, 50Hz/60Hz.

NOTE: Be sure to have all necessary cable connections properly done before connect the power source.

If the player will not be used for a long period of time, disconnect the power and remove the batteries from the remote.

display. Refer to Chapter 4 for more details about all of the Menu features and controls.

Figure 6. Main Menu

- 9 - - 10 -