
Basic Operation
This chapter will describe the steps required for basic operation of the
3.1 Initial Channel Scan
1.To perform a channel scan when the input is from a terrestrial antenna, click the MENU button on the CB
remote control to display the setup menu, press the navigation buttons to highlight “CHANNEL”, press the
navigation button to select “Auto Scan”, press the
direction button or the ENTER button to start auto scan.
Figure 7. Auto Scan Sub-Menu
2.After pressing the navigation button or the ENTER button, the
The auto scan process can be cancelled at any time by pressing the ENTER button on the CB remote control.
0
Figure 8. Auto Scan Status Window
3.After the channel scan is completed, the menu window will disappear, and the converter box will display the first locked channel.
-11 -
Basic Operation
3.2 Changing Channels
One advantage of digital television is the ability for a broadcaster to transmit more than one program
simultaneously on one channel. This is done by using major and minor channel numbers such as
the broadcaster’s signal so it can be viewed on any television in standard resolution.
After scanning, switching between channels can be easily done like changing channels on a regular
television, but there are several ways to do it:
•Use the Channel Up (Ch+) and Channel Down
•Use the Channel Up (Ch+) and Channel Down
•Use the number and dash
(e.g. Enter “1”, “3”,
If the major channel is desired, it is only necessary to enter in the major channel number (e.g. Entering “1”, “3” will tune to channel
• Use the Q.VIEW button to switch to the last channel0 viewed.
- 12 -