2 Setup
2.6 Wire Your System
2.6.1 Stereo Mode
Make sure the amplifier is turned off and the level controls are turned down before you wire the system.
Typical input and output wiring is shown in Figure 2.9.
INPUTS: Connect input wiring for each channel.
OUTPUTS: Maintain proper polarity
Connect
2.6.2 How to Parallel the Inputs
There are three ways to feed the same signal to each amplifier channel:
1.Buy a "Y" cable. Plug the female end into your signal cable, and plug the split male ends into both amplifier inputs.
2.Feed your signal to the
3.Feed your signal to the
See the next page for
Figure 2.9 Typical System Wiring, Stereo Mode
Figure 2.10 Jumper Placement to Parallel the Inputs
Operation Manual | page 9 |