3. Unplug the AC adapter after charging.
DO NOT CHARGE THE BATTERIES MORE THAN 24
HOURS OR MORE THAN RECOMMENDED TIME.
OVERCHARGING MAY DETERIORATE THE PERFORM-
ANCE OF THE RECHARGEABLE BATTERIES.
4. If the operating time decrease drastically after the
batteries have been recharged properly, purchase new
rechargeable NiCd batteries.
Do not attempt to recharge alkaline batteries. This may
cause leakage and damage to the unit.
Do not mix alkaline batteries with rechargeable batteries.
MONEY SAVING TIPS.
Due to the nature of CD technology, the unit uses power
even when the unit is off. To extend the batteries’ life, use
the adapter for indoor operation or where power is
supplied. Use the battery operation only when the unit is in
mobile.
DBBS FUNCTION
The Dynamic Bass Boost System(DBBS) enhances the
low frequency(Bass) response of the output. Set the
Please read and follow the instruction manual
carefully before operating in order to avoid any
damages to the unit. Any adjustment or repair
should be done by a qualified service center only
to receive warranty.
INTRODUCTION
Your unit operates on two(2) AA size alkaline batteries.
Open the CD cover and insert the batteries in the battery
compartment following the polarity diagram located
inside.
BATTERY OPERATION(BATTERIES NOT INCLUDED)
RE-CHARGEABLE BATTERY OPERATION
(RE-CHARGEABLE BATTERIES NOT INCLUDED)
You can operate this unit with two “AA” rechargeable
batteries. For new or exhausted rechargeable batteries,
we recommend to refer to battery manufacturer’s
guide.
2. Plug in AC adapter and slide the “CHARGE SWITCH“
to “ON” position to start charging.(AC Adapter Not Included)
Instruction ManualPortable CD/MP3 Player
with Text Display
MP-CD561
NAME OF PARTS
1
A
1. Open the CD cover and insert the batteries (2x”AA”) in
the battery compartment following the polarity diagram
located inside.
BOTH BATTERIES MUST BE RECHARGEABLE NiCd
TYPES. OTHER BATTERIES MAY EXPLODE OR LEAK.
When operating the unit with AC adapter and non-rechargeable batteries in the compartment, please make sure to set the “Charge” switch to “Off” position to avoid damaging the unit.Insert the disc into the unit with the label of the disc
facing up.
Gently wipe the disc using a soft cloth from the center
to the outer direction to remove dust, fingerprints or any
other particles on the disc surface. Never use
chemicals, such as record sprays, anti-static sprays,
benzene or thinners to clean the CD. These chemicals
can damage the disc surface permanently.
To avoid serious scratches on CD, keep them in the
cases after each use. Scratches can cause the laser
pick-up skip in the future play.
Do not place stickers or write anything on the disc.
Ensure that all electrical connections(including the main
plug, extension leads and interconnections between
pieces of equipment) are properly made and in
accordance with the manufacture’s instructions.
Consult your dealer if you are ever in doubt about the
installation, operation or safety of your equipment.
Read the instruction manual before operating this unit.
Do not expose the unit to high temperature or humidity.
Use dampened soft cloth to clean the unit. Do not use
strong detergent or solvent to clean the unit.
Volume to low listening level and press DBBS switch in
the direction of the arrow to turn this function ON.
Note: Some CD’s with DBBS may exceed the bass
response capacity and can cause distortion. Do not play
DBBS in high volume. Playing DBBS in high volume may
cause damage to the headphone and more importantly to
your hearing.
HOLD FUNCTION
This HOLD function prevents any unwanted function
changes during PLAY or STOP mode. Slide HOLD switch
to the arrow direction (or opposite) to turn the function
ON (OFF). No other function buttons operate on HOLD
mode, except DBBS function.
CAUTION
Hearing experts advise against the constant use of
personal stereos played at high volume. Constant high
volume use can lead to hearing loss. If you experience
ringing in the ears or hearing loss, discontinue use and
seek medical advice.
To remove the disc from its storage case, press down on
the center of the case and lift the disc out. Hold it carefully
by the edges as shown below.
The CD mechanism and the sensitive circuitry may
cause interference to a radio tuner nearby. Do not
operate this unit while operating other radio devices.
Danger This product utilizes invisible laser
radiation. Avoid direct exposure
to the beam.
Caution Use of controls, adjustments or procedures
not listed in this manual may result in
hazardous radiation exposure.
CONCERNING COMPACT DISCS
IMPORTANT
Only compact discs identified with this
mark can be used with this player.
LCD screen will display " NO CD/MP3 " if the unit
cannot read CD track data.
PAUSE
Press PLAY/PAUSE( ) button to pause on/off
alternately,and the time will flash.
STOP
Press OFF/STOP ( )button to stop
play , LCD screen will display the last track
number and total play time.
LISTEN TO DESIRED TRACK
Press FR (or FF ) button to set the desired
track#, press PLAY/PAUSE button to play.
Press FR (or FF ) button to change the track#
during the play mode.
(1)
When CD track data has been read, Unit will start play from No.1
automatically. LCD SCREEN will display the play time.
(4)(2)POWER ON AUTO PLAY
CD MODE
Press POWER ON/ENTER button to turn the power on.
(1)(1)
Then will display
LCD screen will display
"HELLO wellcome" .
LCD screen will display "NO DISC", if CD is not in the
unit.
"wellcome to CD/MP3" .
Press FF button
(3)(1)
DC jackVolume controlHeadphone jackDBBS buttonPLAY/PAUSEbutton(push POWER button upward)ESP/SEARH buttonR/PREVIOUS button(push POWER button to left) During play, press EQ button alternately
can simulate various sound. including:flat/
classic/jazz/rock/pop.