DETAILED INSTALLATION | 7 |
III. BRIDGED SETUP
WARNING: DO NOT OPERATE THIS AMPLIFIER WITH THE TOP COVER REMOVED. NEVER MAKE ANY INTERNAL ADJUSTMENTS WHILE THIS AMPLIFIER IS CONNECTED TO AN AC POWER SOURCE.
BRIDGED operation consists of one AMPLIFIER 10.5 per channel. The amount of power from a stereo AMPLIFIER 10.5 is 100 Watts with 25 Watts class A per channel. A bridged AMPLIFIER 10.5 is 400 Watts with 25 Watts class A per chassis. To bridge, set the MODE switch on the back of the amplifier to the BRIDGED position.
NOTE: TURN THE MAIN AC POWER SWITCH ON THE BACK OF THE AMPLIFIER 10.5 OFF BEFORE ALTERING THE MODE SWITCH OR CONNECTING OR DISCONNECTING ANY CABLES.
Back of AMPLIFIER 10.5
MODE
STEREO
BRIDGED
MODEL
SERIAL NUMBER
The bridging switch commons the inputs of the AMPLIFIER 10.5, were pin 2 of the left XLR commons with pin 3 of the right XLR, and pin 2 of the right XLR commons with pin 3 of the left XLR. Whichever input is used the output of that channel will be the positive signal and the channel which has no input will be the negative signal.
The set up diagram for BRIDGED operation is on the following page.
