UNIT LEG AND CASTER (optional) INSTALLATION
Make sure to follow diagrams to properly install the units adjustable legs or optional casters!!!
1) Install the provided nut to the leg, to the desired height. | NUT | |
(for optional caster installation, start with step #2) | ||
| ||
Skipping step #1 might bend support rails and make the unit |
| |
unstable. This will void any or all warranties. |
| |
2) Locate the |
| |
diagram A, found on the bottom of the unit. (for optional caster |
| |
installation, skip to step #4) |
| |
3) Put the leg (with nut already installed from step #1) into the |
| |
LEG | ||
nut. See diagram A. |
If a nut is already welded onto the support rails, then you do not need to install another nut. Simply screw the leg (with the nut installed onto the leg previously in step 1) into the welded nut on the support rail.
4)For optional caster installation, either screw the caster bolt into the welded nut on the support rails, or, put the caster bolts through the
5)Make sure to properly install all legs. All units require 4 legs. (J3 models require 6 legs)
Desired Height
Diagram A (view of bottom compressor area, from the back)