When You Are Ready
To Set Up Your Tent
–Select a level campsite clear of rocks, branches and other hard or sharp objects.
–Do not set up your tent under trees.
–For best results in windy conditions, position the end of tent into the wind.
14’x14’ 3-Room Dome Tent
Instructions apply to Part Number 9271-191
POLE ASSEMBLY PARTS
(2)Center Tent Part No. 9271A402
Poles (Black)
(2)Side Tent Part No. 9271A405
Poles (Grey)
(2)Rainfly Part No. 9271A403
Poles
Rainfly Part No. 9271A406
1 Layout & Positioning of Tent, Pole Assembly
–Layout and position tent with doors facing desired direction. (illus. 1)
–Stake down tent corners, using the tent stake loops.
Keep the floor taut. (illus. 2)
–Assemble all poles by interlocking
–Insert the longer Center Frame Poles (black) into Center Pole Sleeves. The poles should cross
forming an “X” in the middle of tent. (illus. 1)
–Insert the shorter Side Frame Poles (grey) through the pole sleeves located at the sides of tent. (illus. 1)
Center poles
Side pole
Door 
Door
illus. 1
illus. 2 Tent stake through stake loop
2 Connect Frame to Tent
– Unzip doors.
– Locate the Pin & Ring Systems on either side of the front doors and the corresponding Pin & Ring on the back side of tent.
– Insert one end of Frame Pole onto Pin & Ring System on tent stake loop on either side of the doors. (illus. 3)
–Go to opposite end of pole diagonally from starting point and gradually apply pressure to the pole forming an arch until you are able to insert the Pin into pole end.
–Repeat for second pole.
–Attach tent frame clips to poles.
Center poles
Side pole
Side pole
illus. 4
Center section upright
illus. 3
Ring & Pin System
