End
guylines

3 Raise Ends of Tent

– Insert one end of the Side Frame Pole onto the Pin & Ring System.

– Repeat for other Side pole.

– Go to opposite end of pole and gradually apply pressure until pole arches enough to fit onto pin.

– Attach frame clips.

Grommets for rainfly poles

illus. 5

 

Frame Clips

Side pole

illus. 6

Assembled tent without rainfly. Note the frame clips located on tent. Side pole

4 Attach Rainfly

– Assemble Rainfly Poles by interlocking shock-corded poles.

– Insert rainfly poles into pole sleeves located at the center edges of the underside of rainfly. (illus. 7), (illus. 8)

– Drape rainfly over tent, pole side down. The Rainfly Poles should be over the doors of the tent.

– Insert the ends of the rainfly poles into the grommets on the tent body.

– Secure rainfly with attachments located on underside of fly.

– Attach “S” hooks to the fabric loops near frame clips. (illus. 9)

– Attach guylines to fabric loops on rainfly. Two at each end over side windows and three on the rainfly. Stake out guylines away from the tent at an angle. (illus.10)

illus. 7 Insert rainfly pole through pole sleeve on underside of rainfly.

4 main guylines attach to fabric loops on rainfly.

Frame attachments located on underside of rainfly.

End guylines

illus. 8 Completed tent with rainfly. Note the 2 guylines on each end and 4 main guylines.

illus. 10

 

Stake out tent with adjustable

 

guylines. Slide the disc up the

illus. 9

rope to tighten guyline.

 

Things You Should Know

Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

Seam sealer has not been provided with your tent. For additional protection we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

PRINTED IN THAILAND Rev. 07/04

Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84. The fabric will burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN THAILAND

Page 2
Image 2
Coleman 14'x14 manual Raise Ends of Tent, Attach Rainfly, Things You Should Know