Coleman 2000001200 manual Cooler Access, Electrical Cord Access, To Store, Things You Should Know

To Attach Rainfly continued	Back Awning	Sleeve in Rainfly
	Pole	Awning	Grommet

7.Assemble the interlocking, shock-cord-

ed back awning pole, with metal	Back
tips on the angled end pieces.	Awning Pole
	Back Window
8. Insert back awning pole through
sleeve in rainfly awning at back of tent	Vent of Tent
as shown. (Fig. 6)

9.	Insert metal tip, on back awning pole,			6A
	into metal grommet in upper corner.
			Fig. 6
	(Fig. 6 & 6A)
10.	Go to opposite end of back awning	Front Door &		Back Awning &
	pole and gradually apply pressure to the
				Window Vent
		Vestibule of Tent
	pole to form an arch. Insert the metal			of Tent
	tip on the awning pole into the metal
	grommet. (Fig. 6)

11.Locate all hook & loop fasteners on seams on underside of rainfly and wrap around black main poles to

secure. (Fig. 7A) 7B 7B

12.Tie guylines through loops on web straps on the rainfly. (Fig. 7 & 7B)

13. Stretch guylines until taut, then	Underside
secure with stakes. (Fig. 7C)	of Rainfly	Side View of Tent	7C	Fig. 7

Black

Main

Pole

7A

Cooler Access

The smaller zippered opening at the rear of the tent is designed for added ventilation and easy access to your beverage cooler.

1.To use as a vent, unzip flap to

expose screen. (Fig. 8) Fig. 8

2.To use as a cooler access, unzip other flap to make an avenue to bring beverages into the tent.

(Fig. 9)

Fig. 9

Electrical Cord Access

1.Unzip access panel in the lower left corner of tent and bring in electrical cord. Use only UL approved cords that are rated for outdoor usage. (Fig. 10)

Fig. 10

To Store

1.All metal poles and stakes must be placed in the storage bag to prevent damage to the fabric items placed in the carry case.

2.Make sure tent is clean and dry before placing in carry case.

3.Remove rainfly, spread out on floor of tent, then unzip door & vents before taking tent down for storage.

4.Neatly fold tent to width of pole storage bag, place on tent, roll tightly, and place in carry case.

5.Store in a clean, dry area.

Things You Should Know:

•Under certain conditions (cold weather, high humidity, etc.) condensa- tion will form on the inside of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventila- tion through the tent.

•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT TO REMOVE STAKE.

•TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.

•Do not leave your tent set-up for weeks at a time. Be aware that exposure to ultraviolet rays from the sun can seriously damage material and/or cause it to become discolored.

WARNING: Keep all flame and heat sources away from this tent fabric.

This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA • PRINTED IN CHINA

© 2007 The Coleman Company, Inc.

Coleman® and are registered trademarks of The Coleman Company, Inc.

STITCH LINE

12/07