HOOLIGANTM 4 MODEL 2000001591
STITCH LINE
Before you begin
Read all instructions before set up.
•Select a level site clear of rocks, branches, and other hard or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
•Do not set up your tent under trees because of potential lightning strikes or falling tree limbs in inclement weather.
•Secure with all stakes and guylines provided to prevent property damage or personal injury.
•For best results in windy conditions, position narrow end of tent into the wind.
•Enlist the help of at least one other person to assist you when it is time to assemble the tent.
Pole Descriptions
|
| Pole | Pole | Pole |
Description | Qty. | Dia. | Repair Kit | Replacement Kit |
Main Pole, black | 2 | 8.5mm | 501000541 | 501000547 |
Vestibule Pole, grey | 1 | 8.5mm | 501000541 | 501000547 |
Vent Pole, black, short |
|
|
|
|
with | 1 | 6.3mm | 501000638 | 501000638 |
To Set Up Tent
1.Unfold tent and spread out on a clean, level surface with the door facing perpendicular to the wind direction. Unzip door.
2. Assemble Main Poles by interlocking the black,
3. Insert Main Poles through sleeves in top of tent. (Fig. 1)
Fig. 1
Back of Tent
Door
Main
Pole
Main | Sleeve | Sleeve |
Pole |
| |
|
|
4. | Insert one end of black Main Pole into pin on metal loop | ||
| located at either end of tent. (Fig. 2) | ||
5. | Go to opposite end of Main Pole and gradually apply pressure | ||
| to pole forming an arch. Insert pin into |
|
|
|
|
7. Assemble thin, black, |
| ||
8. Insert Vent Pole through |
|
|
|
| Sleeve | Vent Pole | |
sleeve at back of tent. |
|
|
|
(Fig. 5) |
|
|
|
9. Insert metal tip into |
|
|
|
grommet. Go to opposite |
| Back of Tent |
|
| Fig. 5 | ||
end of Vent Pole and |
| ||
|
|
| |
|
|
| |
gradually apply pressure |
|
|
|
|
|
| |
to pole forming an arch |
|
|
|
then insert metal |
|
|
|
tip into grommet. |
|
|
|
(Fig. 6 & 6A) |
|
|
|
|
|
|
|
6A |
|
| Fig. 6 |
|
|
|
|
To Attach Rainfly
1.Drape Rainfly over tent. Make sure seams on Rainfly are facing down and centered over poles and the vestibule is over to door of the tent. (Fig. 7)
NOTE: Hook and loop fasteners, located on seams of under - side of rainfly, should be centered over black poles.
Rainfly
Vestibule over Door
Front
of Tent
Fig. 7
2.Fold Rainfly at front of tent back as shown in Fig. 8.
3. Assemble Vestibule Pole by interlocking the grey, shock- corded, sections.
4.Insert one end of grey Vestibule Pole into pin on metal loop located at either side of tent. (Fig. 8 & 8A)
5.Go to opposite end of Vestibule Pole and gradually apply pressure to pole forming an arch. Insert pin into the pole end (Fig. 8 & 8A).
the pole end (Fig. 2 & 3). Repeat for the |
remaining Main Pole. |
|
|
| Main |
|
|
| Pole |
|
|
| Metal |
|
|
| Loop |
| Fig. 2 | & Pin | |
|
|
|
|
Stake | Stake |
|
Fig. 3
6. Stretch out corners and sides of |
tent. Drive in stakes at an angle |
through the metal loops to help |
anchor the corners & sides of the |
Hook & Loop
Fasteners
8A
Grey Vestibule Pole
Door
Front of
Tent
Fig. 8
tent. (Fig. 3 & 4) | Fig. 4 |
(continued on other side)