To Light cont
Match Light
Hold match as shown. Turn valve to HI
position.
Heater will ignite with a brief visible flame after
Heater is adjustable to “HI” and “LOW”.
NOTE: Heater is designed to be lit with the valve fully open until it reaches full output. Observe heat build up for a few minutes to ensure heater is lit. If heater fails to develop substantial heat, turn heater “OFF” and repeat lighting procedure.
To Turn Off
To Store cont
.BLFTVSF)FBUFSJT
cool.
5BLFVOJUPVUEPPSTBXBZ
from any ignition sources. Remove Cylinder from Heater.
Replace plastic cap on cylinder.
Store propane cylinder consistent with the instructions and warnings on the cylinder.
Electronic Ignition
Turn valve to HI position and repeatedly push red ignition button until heater ignites.
Heater will ignite with a brief visible flame after
Heater is adjustable to “HI” and “LOW”.
Turn FUEL VALVE to OFF.
Allow HEATER to cool for
To Store
DANGER
• EXPLOSION - FIRE HAZARD
tNever store propane near high heat, open flames, pilot lights, direct sunlight, other ignition sources or where temperatures exceed 120 degrees F (49°C).
Things You Should Know
1.This is a catalytic heater. Burning occurs within the pad at a lower temperature than a normal flame due to evenly distributed platinum. But, heat guard and burner rim still get hot enough to burn you. Be careful.
5IFDBUBMZUJDQSPDFTTUBLFTBQQSPYJNBUFMZ minutes to reach full heat output.
%POPUVTFIFBUFSGPSDPPLJOHPSXBSNJOH items, this can destroy combustion and catalyst. This heater has a low burn temperature (no flame) but it can still burn clothing, sleeping bags, etc., that might fall on the burner surface.
4.To avoid damage to the catalyst, do not allow head pad to come in contact with or around silicone based hand creams, paints, etc.
5.Do not touch the gray ceramic fiber head
QBEPSQPLFBIPMFJOUPJU
6.Do not attempt cleaning the head assembly.
5
