To Light continued
NOTE: If lantern does not light, |
| |
repeat above step. If the lantern | 1/8" | |
does not light after several attempts, | ||
(3 mm) | ||
check for a spark while clicking the | ||
| ||
valve. If no spark is present, check |
| |
the electrode gap. The gap should |
| |
be about 1/8" (3 mm). Bend flat |
| |
electrode to set gap. If the lantern is |
| |
wet due to rain, high humidity, etc., |
| |
the valve may not spark. Use light- |
| |
ing procedure for match light version |
| |
lanterns. |
| |
|
■ Brightness may be adjusted with fuel valve.
To Turn Off
■Turn fuel valve off.
8
To Store
■Make sure lantern is cool.
■Move lantern away from flame (including pilot lights) and other ignition sources.
■Remove propane cylinder from lantern.
■Replace protective cap on propane cylinder.
■Lantern can be placed in base for secure storage.
DANGER
•EXPLOSION - FIRE HAZARD
•Never store propane near high heat, open flames, pilot lights, direct sunlight, other ignition sources or where temperatures exceed 120 degrees F (49°C).
•The cylinder must be disconnected when the lantern is in storage.
