Coleman 9163-151 Attaching Room Divider, Overhead Storage, Electical Cord Access, Cooler Access

Fig. 23

To Attach Rainfly continued

2.Clip hooks on elastic cords on rainfly to rings at bottom of tent. (Fig. 12)

Fig. 12

3.Secure rainfly with hook & loop fasteners located on underside of fly to gray and black poles. (Fig 13)

Fig. 13

4.Assemble black, shock- corded, rainfly pole and slide through sleeve on underside of rainfly. (Fig 14)

5.Insert ends of rainfly

into brass grommets on	Fig. 14
tent to form an arch
over doorway. (Fig. 15)

6.Tie guylines at 4 locations (2 on

front, 2 on back) of tent and secure		Fig. 15
with stakes.
(Fig. 16 & 17)	Tie Guylines	Tie Guylines

Fig. 16 Fig. 17 COMPLETED TENT

7.To open door fully, unzip, then roll up and insert toggle through fabric loop. (Fig. 18)

8.To use the door vent, undo other zipper to expose vent, then roll up door flap and fasten with toggle and fabric loop.

Fig. 18

Attaching Room Divider

1.Room divider panel can be installed by inserting toggles through the fabric loops. (Fig. 19 & 20)

Fig. 19 Fig. 20

Overhead Storage

1.	Convenient overhead stor-
	age compartment is located
	at the back of the tent.
	(Fig. 21)
2.	Small storage pockets are	Fig. 21
	located on each side of tent.

Electical Cord Access

1.Unzip access panel in the lower right corner of tent and bring in electrical cord. Use only UL approved cords that are rated for outdoor usage. (Fig. 22)

Fig. 22

Cooler Access

The smaller zippered opening at the side of the tent is designed for added ventilation and easy access to your beverage cooler.

1.To use as a vent, unzip flap to expose screen. (Fig.18)

2.To use as a cooler access, unzip other flap to make an avenue to

bring beverages into the tent. (Fig.23)

To Store

1.All metal poles and stakes must to be placed in the storage bag to prevent damage to the fabric items placed in the carry case.

2.Make sure tent is clean and dry before placing in carry case.

3.Remove rainfly, spread out on floor of tent, then unzip door & vents before taking tent down for storage.

4.Neatly fold tent to width of pole storage bag, place on tent, roll tightly, and place in carry case.

5.Store in a clean, dry area.

Things You Should Know:

•Under certain conditions (cold weather, high humidity, etc.) condensa- tion will form on the inside of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventila- tion through the tent.

•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•Stakes should be removed by pulling on the stake itself. Never pull on the tent to remove stake.

•TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.

•Do not leave your tent set-up for weeks at a time. Be aware that exposure to ultraviolet rays from the sun can seriously damage material and/or cause it to become discolored.

WARNING: Keep all flame and heat sources away from this tent fabric.

This tent meets the flammability requirements of CPAI-84. The fab- ric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA • PRINTED IN CHINA

	© 2006 The Coleman Company, Inc.
Coleman® and	are registered trademarks of The Coleman Company, Inc.	11/2006

STITCH LINE