Coleman 923D129 manual Raise Sides of Tent, Made In Sri Lanka, Raise Center of Tent, illus

3 Raise Center of Tent

– Assemble center adjustable poles

(red sticker, longer poles). Pole should be initially adjusted to the inner most hole “A”. (illus. 7)

– Insert square end of brace poles into curved roof poles and raise tent upright. (illus. 5, 6, 7)

– Adjustable poles should attach to squeeze pins at bottom of tent. (illus 8)

– Repeat for other center adjustable pole.

Brace pole	illus. 6 When attaching the brace poles to
	the curved poles make sure that the brace
	poles naturally point straight down.
Curved
poles in	illus. 5
pole sleeve
	Shown with center
	brace poles in position
	and curved poles
	through pole
	sleeves.

		illus. 8
	illus. 7 Poles should be initially	Insert squeeze
4	adjusted to the inner most hole “A”.	pin into pole
	Raise Sides of Tent	Brace pole with hole	Rainfly	Rainfly guylines
	– Assemble shock-corded adjustable end poles.
		for rainfly
	– Insert brace poles into end curved roof poles.
	MAKE SURE when attaching the brace poles to	“S” hooks
	the curved poles that the bottom of the brace pole
	naturally points down and toward the center of the
	tent. (illus. 9)

–End poles should attach to squeeze pins at bottom of tent. (illus. 8)

–Drape rainfly over tent and attach “S”

hooks on rainfly into holes in brace
poles. (illus. 9)
– Assemble and insert (short) Vertical
Hinged Door Pole through vertical sleeve
and into bottom pole stop. Gently apply	illus. 9	Stake down
pressure to insert top end into top pole stop	Tent shown completely	doormat	End guylines
and zip sleeve closed. (illus. 9, 10)	set-up. Note the different
– Assemble and insert (long) Hinged Door
	angles of the end poles.
Pole through curved door sleeve and into
top pole stop. Gently apply pressure to insert
bottom end into bottom pole stop and zip
sleeve closed. (illus. 10, 11)
– Attach guylines to the ends of the	Vertical Door
rainfly, 3 guylines at each end, and
	Pole inserts		Long Door
stake out. (illus. 9)
	into sleeve		Pole inserts
	and zips in		into sleeve
			and pole
			stops, then
	illus. 10 Hinged Door		zips in.
	Pole Stop	illus. 11 Hinged Door

Things You Should Know

•Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

•TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

PRINTED IN SRI LANKA Rev. 12/06

•Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN SRI LANKA