Coleman 9260D108 owner manual Sundome 10’x 8 ’, Layout & Positioning, Tent, Pole Assembly

SUNDOME™ 10’x 8 ’

Instructions apply to Part Number 9260D108

When You Are Ready To Set Up Your Tent

–Select a level campsite clear of rocks, branches and other hard or sharp objects.

–Do not set up your tent under trees. –For best results in windy conditions,

position the end of tent into the wind. –See owners manual for more tips.

POLE ASSEMBLY PARTS

Part No. 9260C302

Main Tent

Poles

Part No. 9260B303

Rainfly

Pole

Rainfly Part No. 9260C304

Layout & Positioning	2	Connect Frame to Tent
1 of Tent, Pole Assembly		–Insert one end of main tent pole end
–Layout and position tent with door		onto pin of ring and pin system, at tent
		corner. (illus. 4)
facing desired direction. (illus. 1)
		–Go to opposite end of pole and
–Unzip door
		gradually apply pressure to the pole
–Stake down tent corners only, using the
		forming an arch until you are able to
rings at the end of the stake loops.
		insert the pin into the pole
Keep the floor taut.
		–Repeat for second pole
–Assemble Frame Poles by
interlocking shock-corded poles.		illus. 3
This will make two long poles.
		Frame Tie
–Insert the poles diagonally into Pole
Sleeves.The center of the poles should
cross forming an “X” in the middle of
tent. (illus. 1)
–Fasten Frame Tie on top of tent over
both poles. (illus. 1), (illus. 3)

Assembled
poles		Frame Tie	Tent frame
inserted
			set-up
through
pole
sleeves
	illus. 1		illus.4
			Insert pole end onto
			pin & ring
		illus. 2 Tent stake
		through ring