Coleman 9277-907 manual Before you begin, Parts and Components, To Set Up Tent, To Attach Rainfly

ARATM 9’ X 7’ MODEL 9277-907

STITCH LINE

Before you begin

Read all instructions before set up.

•Select a level campsite clear of rocks, branches, and other hard or sharp objects, to install your tent.

WARNING: Keep clear of overhead power lines.

•Do not set up your tent under trees.

•For best results in windy conditions, position end of tent into the wind.

•Enlist the help of at least one other person to assist you when it is time to assemble the tent.

Parts and Components

Description	Part Number
Main Poles (2)	9277-1091
Front/Awning Pole, Gray (2)	9277-1101
Rainfly	9277-1121

To Set Up Tent

1.Unfold tent and spread out on a clean, level surface with the door facing the desired direction. Unzip door.

2. Assemble main tent poles by interlocking both longer, black shock-corded, poles.

3. Insert black poles through sleeves in top of tent forming an “X” as shown. (Fig. 1)

Fig. 1

4.Insert one end of each black pole into pins in rear corners of tent. (Fig. 2)

Fig. 2

5. Go to opposite end
of each pole and
gradually apply
pressure to the pole
forming an arch.
Insert the pin into
the pole end at the
tent corners. (Fig. 3)
6. Stretch corners of	Fig. 3
tent until floor is taut

then hammer stakes through loops to secure.

7.Attach frame clips along edges of tent to frame poles (Fig. 4)

Fig. 4

To Set Up Tent (continued)

8.Assemble the interlocking shock-corded, gray pole.

9.Slide pole through sleeve on front of

tent. (Fig. 5) Fig. 5

10.Pull down on pole and insert into center pin location on side of tent. (Fig. 6)

11.Go to opposite side of tent and gradually apply

pressure to the pole to

form an arch. Insert the Fig. 6 pin into the pole.

12.Attach frame clips along edges of tent to frame poles. (Fig. 7)

Fig. 7

To Attach Rainfly

1.Assemble remaining interlocking shock-corded rainfly pole (gray pole).

2.Drape rain fly over tent. Make sure end with two flaps is centered over the door.

3.Slide gray pole through sleeve in

rainfly. (Fig. 8) Fig. 8

4.Insert one end of each rainfly pole into remaining pin in front corner of tent. Gradually apply pressure to other end of pole to form an arch & insert into other front pin. (Fig. 9)

Fig. 9

5.Hook clips on elastic loops of rainfly onto rings on all four corners of the tent. (Fig. 10)

Fig. 10

6.Secure rainfly with velcro hook & loop ties located on underside of fly. (Fig. 11 & 12)

Fig. 11 Fig. 12

(continued on other side)