MONTANA™ 14’x7’
Instructions apply to Part Number 9279A147
When You Are Ready
To Set Up Your Tent
–Select a level campsite clear of rocks, branches and other hard or sharp objects.
–Do not set up your tent under trees.
–For best results in windy conditions, position the end of tent into the wind.
POLE ASSEMBLY PARTS
(2) Main Tent Poles | Part No. 9279A3451 |
|
| |
(Black) |
|
|
|
|
|
|
|
| |
(2) Side Tent Poles | Part No. 9279A3461 |
|
| |
(Grey) |
|
|
|
|
|
|
|
| |
(2) Rainfly Poles | Part No. 9279A3481 | Rainfly Part No. | ||
|
|
| 9279A3491 | |
|
|
| ||
1 Layout & Positioning
of Tent, Pole
Assembly
–Layout and position tent with door facing desired direction. (illus. 1)
–Unzip door.
–Stake down tent corners, using the tent stake loops. Keep the floor taut. (illus. 2)
–Assemble all poles by interlocking
–Insert the black poles into center pole sleeves. The poles should cross forming an “X” in the middle of tent. (illus. 1)
Black poles
Front door
illus. 1
illus. 2 Tent stake through stake loop
2 Connect Frame to Tent
– Locate the pin & ring systems on either side of the front door and the corresponding pin & rings on the back side of tent.
– Insert one end of black frame pole onto pin & ring system on tent stake loop on either side of front door. (illus. 3)
– Go to opposite end of pole diagonally from starting point and gradually apply pressure to the pole forming an arch until you are able to insert the pin into pole end.
– Repeat for second pole.
– Attach tent frame clips to poles.
Black poles
illus. 4
Center section upright
illus. 3
Pin & ring system located on the front & rear of tent
