Coleman 9279A147 manual Attach Rainfly, Raise Ends of Tent, Made in China, Things You Should Know

3	Raise Ends of Tent
	– Insert grey shorter shock-corded poles
	through pole sleeves at both ends of
	tent above windows.
	– Insert second pin (located near center of
	tent) of pin & ring system into pole end.
	– Go to opposite end of pole and
	gradually apply pressure to the pole
	forming an arch until you are able to
	insert the pin into the pole end.
	– Attach frame clips. (illus. 5)	illus. 6

illus. 5 Frame clips

Assembled tent without rainfly.

Grommets for rainfly poles

Grey poles

4 Attach Rainfly

– Assemble rainfly pole by interlocking shock-corded pole.

– Insert rainfly pole into pole sleeves located at the center edges of the underside of rainfly. (illus. 7), (illus. 8)

–Drape rainfly over tent, pole side down. The rainfly pole should cover the door and rear window of tent.

–Insert rainfly pole into grommets on tent body. (illus. 6)

–Secure rainfly with attachments

located on underside of rainfly.

–Attach “S” hooks to the fabric loops near frame clips. (illus. 9)

– Stake out all guylines. (illus. 10)

illus. 9

illus. 7 Insert rainfly pole through pole sleeve on underside of rainfly.

End guylines

	Stake down
illus. 8	doormat

Completed tent with rainfly.

illus. 10

Stake out the tent with adjustable guylines.

Things You Should Know

•Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

•TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

•Seam sealer has not been provided with your tent. For additional protection we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

PRINTED IN CHINA Rev. 9/05

•Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84. The fabric will burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA