2 Attach Shelter to Frame
– With the frame still partially set up, clip the center of the Screen House to the center hub. (illus. 3)
– Starting towards the center of the Screen House, clip the shelter fabric to the poles.
Start by attaching the center of the Screen House to the pole hub.
3 Complete Shelter
– Fully extend each pole by straightening all
– Insert the pin on the pin and ring system, at the corner of the Screen House into the the pole end.
(illus. 4), (illus. 6)
– Repeat for remaining poles.
– Adjust poles to pull the shelter taut and stake down through the fabric loops at the end of pin and ring. (illus. 5), (illus. 6)
– Attach guy lines to fabric guy loops at each corner
and stake out. (illus. 6)
illus. 4
Insert into the
pole end
illus. 3 Screen House clipped to
partially assembled frame
illus. 6
Completed shelter with guy lines staked out
illus. 5
Stake through
stake loop
Things You Should Know
•Never store shelter, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your shelter. Use separate storage bag.
•STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE SHELTER FABRIC OR STAKE LOOP TO REMOVE STAKE.
•SHELTER POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.
•Do not leave your shelter
WARNING: Keep all flame and heat sources away from this shelter fabric. This shelter meets the flammability requirements of
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
MADE IN SRI LANKA
PRINTED IN SRI LANKA Rev. 11/04