Coleman 9972 Series instruction manual To Adjust Igniter, To Turn Off

To Adjust Igniter

NOTE: A gap of 1/8” should be maintained between the end of the wire on the electrode and the burner tube for proper ignition spark. (Fig. 21)

1.Set on sturdy, flat surface.

2.Grasp end of wire with a needle nose pliers and carefully bend to adjust to proper spacing from burner tube (Fig. 21). Be careful to not break or crack the ceramic insulator.

Fig. 21

1/8” Gap

To Light

To Match Light

CAUTION

Use a long wooden match or a match extension

1.Set on sturdy, flat surface. For outdoor use only.

2.You may operate the grill with only the left, only the right, or both burners as needed.

3.Hold a lighted match near the burner, then push the control knob

in and rotate counter-clockwise to the fully open position. (Fig. 22)

4.Repeat Step 3 to light the second burner.

5.Adjust flame with control valve. (Fig. 23)

6.A good flame should be blue with minimal yellow tip. Some

yellow tips on flames are acceptable as long as no carbon or soot deposits appear. (Fig. 24)

NOTE: If the burner flame is accidentally extinguished, turn off the control valve and wait 5 minutes before relighting the appliance.

To Turn Off

1.Turn control valves to OFF. (Fig. 25)

Fig. 22

Fig. 23

Fig. 24

GOOD BAD

Blue

Yellow

Yellow Blue

Holes in Burner

Fig. 25

11