Lighting the Grill continued

Step 3

Turn Righthand Burner Valve to “High.”

Press Igniter Button to light. NOTE: If the flame doesn’t imme- diately light, turn off control knob and wait five minutes for gas to clear.

Repeat steps 1 through 3.

If the burner does not light on second try, turn off knob and try match-lighting the burner.

Repeat steps 2 and 3 for Lefthand L.P. gas cylinder and Lefthand Burner.

NOTE: You must push Igniter Button to ignite the second side of the grill.

■ All Burner Valves can be adjusted from “Low” to “High.”

Match Lighting

Use a LONG wooden match or the match extension provided. Make sure all burner controls are off except one being lighted.

Insert a match in the holder end of the extension, strike the match and place the match near the burner from above.

Turn on BURNER CONTROL KNOB while holding match near burner.

You must use another match to ignite the second side of the grill.

Tear Down/Clean

Step 1

Make sure Burner Valves are in OFF position.

Allow unit to cool completely.

Step 2

Turn off fuel supply on both L.P. gas cylinders.

10

Tear Down/Clean continued

Step 3

Remove Regulators from Propane Cylinder Connection.

Step 4

Remove Grease Pans. Slide out from front of grill to clean or install new aluminum liners in Grease Pans.

Step 5

Unlock tab as shown.

Slide out Grease Tray.

Clean thoroughly before storing grill.

Slide Grease Tray back into position under grill and lock tab.

Page 10
Image 10
Coleman 9995A manual Tear Down/Clean, Match Lighting