Coleman warranty Description, Warranty, Features, Technical Guide, MODELS TG9S

TECHNICAL GUIDE

95.5% SINGLE STAGE GAS-FIRED RESIDENTIAL MULTI-POSITION GAS FURNACES

MODELS: TG9S

NATURAL GAS

40 - 130 MBH INPUT

400992-CTG-B-0708

DESCRIPTION

These compact units employ induced combustion, reliable hot surface ignition and high heat transferaluminized tubular heat exchangers. The units are factory shipped for installation in upflow or horizontal applications and may be converted for downflow applications.

These furnaces are designed for residential installation in a basement, closet, alcove, attic, recreation room or garage and are also ideal for commercial applications. All units are factory assembled, wired and tested to assure safe dependable and economical installation and operation.

These units are Category IV listed and may be vented either through side wall or roof applications using approved plastic combustion air and venr piping.

WARRANTY

Lifetime limited warranty on the heat exchanger.

10-year heat exchanger warranty on commercial applications.

5-year limited parts warranty.

FEATURES

•Easily applied in upflow, horizontal left or right, or downflow installation with minimal conversion necessary.

•Compact, easy to install, ideal height 33" tall cabinet.

•Blower-off delay for cooling SEER improvement.

•Easy access to controls to connect power/control wiring.

•Built-in, high level self diagnostics with fault code displays standard on integrated control module for reliable operation.

EFFICIENCY

RATING

CERTIFIED

ISO 9001

Certified Quality

Management System

Due to continuous product improvement, specifications are subject to change without notice.

•Low unit amp requirement for easy replacement application.

•Single wire twinning or staging feature available.

•All models are convertable to use propane (LP) gas.

•Electronic Hot Surface Ignition saves fuel cost with increased dependability and reliability.

•100% shut off main gas valve for extra safety.

•4 speed, direct drive PSC motor.

•24V, 40 VA control transformer and blower relay supplied for add-on cooling.

•Hi-tech tubular aluminized steel primary heat exchanger.

•Secondary heat exchanger made of corrosion resistant stainless steel materials.

•Timed on, adjustable off blower capability for maximum comfort.

•Blower door safety switch.

•Solid removable bottom panel allows easy conversion.

•Airflow leakage less than 1% of nominal airflow at ductblaster conditions.

•No knockouts to deal with, making installation easier.

•Movable duct connector flanges for application flexibility.

•Quiet inducer operation.

•Inducer rotates for easy conversion of venting options.

•Fully supported blower assembly for easy access and removal of blower.

Visit us on the web at www.york.com for the most up-to-date technical information.

Additional efficiency rating information can be found at www.gamanet.org.

•External air filters used for maximum flexibility in meeting customers IAQ needs.

•Protection included from air intake, exhaust vent, or condensate blockage.

•Patent pending self priming internal condensate trap design for easy installation.

•Venting applications - may be installed as a either 2-pipe (sealed combustion) or single-pipe vent (using indoor combustion air.

•No special vent termination required.

•1/4 turn knobs provided for easy door removal.

FOR DISTRIBUTION USE ONLY - NOT TO BE USED AT POINT OF RETAIL SALE