Coleman X4 warranty Tent Configuration Section, To Assemble Right or Left Side Awning

Tent Configuration Section

The following chart is designed to show the variety of options available for access or ventilation with the X4 Tent. By zipping or rolling up the flaps on the Rainfly, Inner Tent, or a combination of both, you can provide access, privacy or maximum cross ventilation to enhance the camping experience.

Rainfly Options

Awning 1	Zipped	Rolled	Awning*
Awning 2	Zipped	Rolled	Awning*
Front Door	Zipped	Rolled
Back Door	Zipped	Rolled

*See following Awning Assembly instructions below.

Inner Tent Options

Side Door 1	Zipped	Rolled
Side Door 2	Zipped	Rolled
Front Door	Zipped	Rolled
Back Door	Zipped	Rolled
Inner Door	Zipped	Rolled
2 Ceiling Vents	Zipped	Rolled

To Assemble Right or Left Side Awning

3. Insert curved end of Gold Leg Poles into gold-colored fittings on Center Support Pole; then insert curved end of Chrome Center Poles into chrome-colored fittings on Center Support Pole. (Fig. 3)

4. Insert bottom end of the four Gold Leg Poles into grommets on corner web straps (Detail A); then insert bottom end of the four Chrome Center Poles into grommets on center front & back web straps (Detail B).

	Center
	Support Pole
Gold Leg	Chrome	Gold Leg
	Leg
Poles		Poles
	Poles

1. Unzip the right or left side Awning Flap on Rainfly. Select which awning you prefer to use, then insert the two furnished Awning Poles into grommets on web straps. (Detail A)

2. Tie guylines onto loops on the web straps, extend out, and secure with stakes. (Fig. 10)

Web Strap

Detail A

FIG. 3

Detail B

Guyline

Detail A

FIG. 10

5.Snap both center hooks on top of tent onto middle section of the Center Support Pole. (Fig. 4 & 5)

NOTE: Unzipping Bedroom Door Panel and Living Area Door Panel will allow easier access to attaching the center hooks of the tent to the Center Support Post.

Living Area

Door Panel

Bedroom

Door

Panel

FIG. 4 FIG. 5

6 3