3 
!
Setup and
Adjustments
This owner’s manual | " |
| |
covers various models | Figure 1 |
of lawnmowers. The | |
units illustrated may |
|
vary slightly from your |
|
unit. Follow only those |
|
instructions which |
|
pertain to your model |
|
lawnmower. |
|
| ! |
IMPORTANT |
|
This unit is shipped |
|
WITHOUT GASOLINE | Figure 2 |
or OIL. After assem- |
|
bly, service engine |
|
with gasoline and |
|
oil as instructed in |
|
the separate engine |
|
manual packed with |
|
your unit. |
|
B
C
Figure 3
| NOTE: Reference to right, left, front and rear | |
| of the lawn mower is in relation to the operating | |
| position. | |
| WARNING: Disconnect and | |
| ground the spark plug wire as | |
| instructed in the separate engine | |
" | manual. | |
1. Remove any packing material which may be | ||
| ||
| between upper and lower handles. |
a. Pull up and back on the upper handle to raise the handle into the operating position. Position A.
b. Tighten knobs securing upper handle to lower handle. Make sure that each car- riage bolt is seated properly in the handle. Position B.
2. Locate hairpin clip in one hole on the weld pin on each side of lower handle. Figure 2.
a. Remove hairpin clip from this hole. Using a pair of pliers, insert hairpin clip into the other hole on the weld pin. Repeat on other side. Position A.
A | 3. Rope guide Setup as follows, see Figure 3. |
a.Hold the blade control against the upper handle. Position A.
b.Slowly pull starter rope out of engine. Position B.
c. Slip starter rope into the rope guide. Posi- tion C.
D | d. Tighten rope guide wing nut (star knobs). |
Position D. |
