Compaq NAS B3000 manual Standard Features

QuickSpecs

StorageWorks NAS B3000 by Compaq

Standard Features

P r o c e s s o r	Model N900, C900, N900s, C900s
	Two (2) Intel Pentium III Xeon 900-MHz processors (upgradeable to 4)
Cache M emor y	2-MB level 2 write back cache per processor standard
Memor y	Standard	2 GB (512 x 4 PC100MHz ECC SDRAM Memory with Advanced ECC functionality)
	Maximum	4 GB

NOTE: Advanced ECC Memory Technology protects the data even in the event of an entire SDRAM component failure. Embedded in the chipset design, this feature allows the use of Industry-Standard Registered DIMMs.

Upgrad abi li ty	Upgradeable to four processors, upgradeable to 4 GB of ECC SDRAM, upgradeable storage capacity
Networ k Con trol ler	Integrated Compaq NC3134 Fast Ethernet NIC 64 PCI Dual Base 10/100 in a slot and a Compaq NC3135 Fast
	Ethernet NIC 64 PCI dual 10/100 daughter card (total 10/100 ports is 4)			(Gigabit options available)
Host Ad apter s	FCA2101 Host Bus Adapter
Expan sion Slo ts	I/O (6 Total, 2 Available)			PCI Voltage:
	Two (2) 64-bit/66-MHz PCI Hot Plug		1 available	3.3 Volt Only
	Two (2) 64-bit/33-MHz PCI Hot Plug		0 available	5 Volt or 3.3 Volt
	One (1) 64-bit/33-MHz PCI Non-Hot Plug		0 available	5 Volt or 3.3 Volt
	One (1) 32-bit/33-MHz PCI Non-Hot Plug		1 available	5 Volt Only
	NOTE: One 64-bit/66-MHz PCI Hot Plug slot available and one 32-bit/33-MHz PCI Non-Hot Plug slot available
Stor age Con tro ll er	Integrated Smart Array Controller (Two channel) (supports Internal RAID 0, 1, 0+1, 5 and external tape devices)
Internal Sto rag e	Diskette Drives	1.44 MB
	CD-ROM	24x IDE CD-ROM Drive (slim line)
	Hard Drives	Two 1″ 36.4-GB Ultra3 10K rpm hot plug drives (contain operating system in a
		RAID 1 configuration)
	Maximum Internal Storage	78.2 GB (2 x 36.4-GB Wide Ultra3 1″ drives)
Extern al S tor age	Minimum External Storage	MSA1000	(4 (for non-clustered) to 6 (for clustered) x 72-GB drives depending on
		model)
Interfaces	Parallel	Not supported
	Serial	1
		NOTE: You can configure a second serial device to your NAS B3000 server by
		installing the auxiliary serial connector that ships with the server. The
		auxiliary connector attaches to a serial port B on the peripheral board
		and exits the rear of the server through the auxiliary serial knockout
		located directly above the dual power feeds.
	Pointing Device (Mouse)	1
	Graphics	Available through the “Remote Insight Board” only
	Hot Plug Keyboard	1
	External Wide Ultra2 SCSI	1

DA-11339 Canada — Version 7 — September 24, 2002 4