22 Chapter6 - Basic Configuration Guide
CV: Usethe Physical Con figuration: WAN1 Dial og Box.
TB: Use configure ands et the LinkTypeke yword or other keywords
int he RS232Interface WAN 1 section.
PPP Configuration
This sectionco vers thes ettings required forPP P(po int-to-point)
protocoloperation of the WAN interfaces.
Internal T1 CSU/DSU (WAN 0) Link Configuration
Requiredfor Dedicated Line Operation
This isth e only mode of operation supported via the built-in T1
CSU/DSU.
• SetPP P connection
CV: Usethe Link Configuration: WAN 0 Dialog Box.
TB: Use configure and set the Mode keywordin the Link Config
WAN 0 section.
Suggestedfor Dedicated/Leased Line Operation
Dedicatedli ne operationgenerally does notrequire additional parame-
tersfor operation.

RS-232 (WAN 1) Link Configuration

Requiredfor Dedicated/Leased Line Operation
Dedicatedli ne operationi s thes implest to set up.
• SetDedicated connection
• SetPP P connection
CV: Usethe Link Configuration: WAN1 Dialog Box.
TB: Use configureand set the Mode and ConnectMode keywords in
the LinkConfig WAN 1 section.
Suggestedfor Dedicated/Leased Line Operation
Dedicatedli ne operationgenerally does notrequire additional parame-
tersfor operation.
Requiredfor Dial-On-Demand Operation
Thismode of operation is only supported on the WAN 1 RS-232 inter-
face. Incoming dial-on-demand operation requires only slightly more