22 Chapter 6 - Basic Configuration Guide
CV: Use the DECnet Routing Dialog Box (under Global/DECnet
Routing) and the DECnet: Ethernet Dialog Box.
TB: Use configure and set the Enabled, Area, and Node keywords in
the DECnet Global section.
v Note: Setting DECnet on for any port with the command line also
sets DECnet on globally. In CompatiView you must set a global
parameter and a port-specific parameter.
Suggested for DECnet
Setting the parameters above should be adequate for most installations.
WAN Interface Configuration
This section covers the settings required for PPP (point-to-point)
protocol operation of the RISC Router 3500R WAN interfaces. In
general, the parameters listed here should be set for each WAN inter-
face on which you plan to use PPP. Note that some WAN interfaces can
be running PPP while others are running Frame Relay .
The V.35 interface can only be run synchronously, at rates up to 2 Mbps
per second.

Physical Communications Settings

You may need to set the baud rate, sync/async operation, and other
physical communications parameters for the WAN interface. These
parameters will depend on the line communications device you are
using.
CV: Use the Physical Configuration: WAN 0 Dialog Box.
TB: Use configure and the V.35 Interface WAN 0 (and/or other port
numbers you wish to configure) sectio n .