More Button Functions
(1) Time Setting
| Button | PressedFor | Function |
|
STEP 1 | (II+III)- | 2 sec | Tones will sound for confirmation |
|
|
|
|
| |
STEP 2 | (I) | 1/2 sec | Time setting is on. The numbers will |
|
flash, and tones will sound. |
| |||
|
|
|
| |
|
|
|
|
|
STEP 3 | (I) | 1/2 sec | Change hour. |
|
(II) | 1/2 sec | Change minutes. |
| |
|
| |||
STEP 4 | (II+III)- | 2 sec | Time setting is off. Tones will |
|
sound. |
| |||
|
|
|
| |
|
|
|
|
|
(2) RPS & Vibration mode on or off
| Button | PressedFor | Function |
|
STEP 1 | (II+III)- | 2 sec | Tones will sound for confirmation |
|
|
|
|
| |
| (III) | 1/2 sec | RPS on or off, tones will sound for |
|
|
|
|
| |
STEP 2 |
|
| confirmation. |
|
| (IV) | 1/2 sec | Vibration mode on or off, tones will |
|
|
|
|
| |
|
|
| sound for confirmation. |
|
|
|
|
|
|
|
|
|
|
|
Note : Step 2 must be completed within 15 seconds. If not, start over at step 1.
Remote-Pager Learn Routine
The CompuStar system will allow up to three remotes to be programmed to one vehicle. Please perform the following procedure to add or reprogram additional remotes.
Step1 : Activate Valet/Programming mode by manually turning the ignition on and off five times (between Acc and On)
with the key within a 7 second period.
The parking light will flash once with successful completion of this step.
Step2 : Within a 7 second period after cycling the ignition for the 5th time, press button I. The parking lights will flash once to confirm that the
transmitter has been programmed. You can continue programming additional remotes. The parking lights will flash two times when the programming mode has expired.
Auto-Start Function
Press button II for 2 seconds to
For manual transmission vehicles, please use reservation mode.
Press button II for 2 seconds in order to turn off an
The engine will run 15 or 25 minutes (25 or 45 min for diesel) depending on preset options at the time of installation and then shut off.
- | shows the amount of |
| start mode. |
Anti-Grind
The
Page 8 | Page 9 |
