NOTE
This steamer is designed to sit on the floor. Do not put on a table or chair when in use.
OTHER IMPORTANT NOTES
During operation, the steamer hose may gurgle. This is a normal result of condensa- tion collecting inside the hose. Simply lift the "T" handle upward until the hose is extended to its full height. The gurgling will disappear when the excess moisture inside the hose has had a chance to drain back into the base.
Caution: Hose will be hot when in use. Avoid prolonged contact.
HOW TO STEAM
Grasp the "T" handle steam nozzle with the steam jets facing away from you. Begin at the bottom of the fabric to allow the steam to rise inside and outside, removing wrinkles. Slowly move the nozzle from the bottom to the top of the fabric. Remove the nozzle from the garment and smooth the fabric with your free hand. Some fabrics are best steamed on the underside of the material. This will allow the fibers of the fabric to relax, eliminating wrinkles.
NOTE: Test fabric for color fastness in an inconspicuous spot. Drape linens, towels, handkerchiefs and napkins over a rod or place onto a towel rack.
Heavier fabrics may require repeated steam- ing. Repeat as necessary.
With practice, you will gain speed and efficiency. You will soon learn which fabrics require multiple steam applications.
Do not directly touch velvet or silk with the steam head.
Always steam with hose in upright position so any condensation is free to flow back into the steamer.
If you steam in a low position, condensation will collect inside the hose. This will cause gurgling and some water droplets to form near the steam jets on the "T" handle. To avoid this, frequently lift the steam handle upward until the hose is extended to its full height.
To steam drapes:
Wash and dry drapes as directed according to fabric type.
CLEANING AND STORING
I. Turn the ON/OFF switch to the OFF position and unplug from the power source.
2.Wait for the steamer to cool completely for at least 30 minutes.
3.Unplug power cord and gently wrap around
4.Remove excess water from the reservoir by lifting the unit and pouring the water down a drain.
5.Wrap hose around container and replace
DECALCIFICATION
If the appliance begins to produce steam more slowly than usual, or stops producing steam and then starts again, you may need to decalcify your steamer. Decalcification refers to removing the calcium deposits that form over time on the metal parts of the steamer. For best performance from the Conair Garment Steamer, decalcify the unit from time to time. The frequency depends upon the hardness of your tap water and how often you use the steamer.
To decalcify, use a solution of 1/3 white vinegar and 2/3 water in the water reservoir. Plug the unit into electrical outlet. Turn to the ON position and run until half the amount has steamed. Turn the unit to the OFF position, unplug from electrical outlet, and allow to sit for 30 minutes.
Remove excess water from the reservoir by lifting the unit, inverting and pouring the water into a sink, allowing water to drain from internal reservoir. Repeat the above procedure as many times as necessary until a normal steam rate returns, usually 2 to 3 times. With each repeated cycle, use a fresh solution of vinegar and water. Run one cycle of fresh, cold water through the unit at the completion of decalcification before using the unit again to steam garments.
TROUBLESHOOTING THE STEAMER
•PROBLEM - No steam
CAUSE - Steamer not turned on SOLUTION - Turn ON/OFF switch to ON position and wait 2 minutes
•PROBLEM - Steamer fails to heat
CAUSE - Steamer not plugged in SOLUTION - Plug into electrical outlet
•PROBLEM - No steam
CAUSE - Water level is low SOLUTION - Turn ON/OFF switch OFF and refill water container
•PROBLEM - Water drips from nozzle
CAUSE - Condensation in hose SOLUTION - Hold the hose vertically and allow water to drain back into unit
•PROBLEM - Nozzle gurgles
CAUSE - Condensation in hose SOLUTION - Hold the hose vertically and allow water to drain back into unit
•PROBLEM - Poor steam performance
CAUSE - Sediment in container SOLUTION - Decalcify reservoir and water container
Note: Minerals in water will vary in different areas. To ensure continued oper- ation of the steamer, never store without cleaning and removing excess water from
LIMITED ONE YEAR WARRANTY
Conair will repair or replace (at our option) your unit free of charge for 12 months from the date of purchase if the appliance is defective in workmanship or materials.
To obtain service under this warranty, return the defective product to the service center listed together with your purchase receipt and $3.00 for postage and handling. California residents need only provide proof of purchase and should call
ANY IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE
Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER. Some states do
not allow the exclusion or limitation of special, incidental, or consequential damages, so the above limitation may not apply to you. This
Service Center
Conair Corporation
Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
For information on any Conair product call:
Please register this product at:
www.conair.com/registration
compact
fabriccommercial quality
steamer
Convenient to use on CLOTHES, DRAPES & LINENS
jet
Using the
Ready for storage
the reservoir and water container.
warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
©2011 Conair Corporation
East Windsor, NJ 08520 Glendale, AZ 85307
11PA118508IB-10785
Instructions for Use
Model GS61
For your safety and continued enjoyment of this
product, always read the instruction book
carefully before using.
