Connect Tech CTIM-00054 Power Notes, Product Errata, PCI/104-Express Power Specifications

PCI/104-Express to PCI Express Adapter

5. Power Notes

Some PCI/104-Express SBC systems will not come with +3.3V power over the PCI/104-Express connector. If this is the case, enable jumper block J1 Position A** (See errata) to enable the on board regulator to generate +3.3V (which is limited to 1.5A) for your PCI Express card. If the SBC you are using does provide +3.3V power, do not enable this jumper.

PCI/104-Express Power Specifications

Please refer to your PCI/104-Express SBC manual for actual ratings used.

6. Product Errata

ADG020 Limitations

This product provides a single x1 lane PCI Express connection. PCI Express x4, x8 or x16 lane cards cannot be used. Please use the ADG017 board for this functionality.

This product only provides +3.3V power to the PCI Express connector it does not provide any +12V. Please ensure your x1 PCI Express board does not use +12V. Please use the ADG017 for full +12V operation.

Silkscreen Corrections **

The silkscreen label for Jumper block J1 is incorrect on all Rev. A PCBs.

It should read:

Position A - ON: Use +3.3V regulator

OFF: Use +3.3V from PCI/104-Express

Position B -	ON:	Select x4, x8 or x16 Lane Link
	OFF:	Select x1 Lane Link

9	www.connecttech.com	CTIM-00054 (0.01) 3/26/2010
	800-426-8979 519-836-1291