Contec CS2000 Entering Program Mode, Table of Features, Output Mode, Light/Dark Operation

Program Mode

Entering Program Mode:

Program Mode is used to change any or all of the Operation Features. To enter Program Mode depress the push-button until the yellow and green LED's begin toggling (30 sec.), then release. The LED's will then output the current set-up configuration (and every 3 sec. thereafter). For example: an output of yellow, yellow, yellow tells you that the current configuration is Level Shift, Light Operate, and Normal Contrast Setting.

Table of Features:

1				OUTPUT MODE
	*A. Level Shift - (default factory setting)							Yellow LED
	B Pulse							Green LED
			LIGHT/DARK OPERATION
	*A. Output on Web - Light - (default factory setting)							Yellow LED
		Level Shift Output			Pulse Output
		WEB	LABEL		LABEL	WEB		LABEL
		ON				ON
2			OFF		OFF			OFF
						2	m.s.
	B. Output on Label - Dark							Green LED
		Level Shift Output			Pulse Output
		WEB	LABEL		LABEL	WEB		LABEL
			ON		ON	2 m.s.		ON
		OFF
						OFF
3			CONTRAST SETTING
	*A. Normal Contrast Setting - (default factory setting)							Yellow LED
	B. Low Contrast Setting							Green LED

Changing a Feature:

To change a feature, depress the push-button the corresponding number of times. This will change the current feature from A to B, or from B to A. For example: If you wanted to change the output from Level Shift to Pulse, you would depress the push-button 1 time - the LED's would then output green, yellow, yellow. Repeat this step if you want to change more than one feature.

Exiting Program Mode:

To exit Program Mode depress the push-button until the yellow and green LED's begin toggling (2 sec.), then release. This puts you back in the standard operating mode.

- 12 -