Continental Home MATE2 manual AGS state can be one or more of the following numbers

ADV/MATE/AGS/PG3---------------

choose category

%SOC

PG2 START TIMERS PG4

ADV/MATE/AGS/TIMERS------------
agsstate	0
DOWN	AGS

ADV/MATE/AGS/TIMERS	----------
agsgenfault	0
DOWN UP

ADV/MATE/AGS/TIMERS---------
24 hr	1440 min
vs time
DOWN	UP

ADV/MATE/AGS/TIMERS---------

2hr vs time 120 min

DOWN UP

ADV/MATE/AGS/TIMERS---------
2 min	2 min
vs time
DOWN	UP

Press the <TIMERS> soft key to view the various AGS timer-related screens.

The agsstate screen displays a numeric value corresponding to why the generator is or is not running. This is a diagnostic feature for OutBack troubleshooting purposes. Press the <DOWN> soft key to view the next TIMER screen.

AGS state can be one or more of the following numbers:

Manual Start	128
Exercise	64
Time of Day	32
Load Start	16
Voltage 24hr/2hr	8
Voltage 2min	4
SOC Start	2

An AGS state of 128 means that AGS is active because of a manual start. More then one reason can be true at any one time (e.g., AGS state of 20 would be load start and 2 min voltage timer). The generator will be running any time AGS state is greater then 0.

The agsgenfault screen displays three states:

•0 or no generator fault

•1 indicates the generator did not start and there is no AC input after five minutes

•2 indicates the generator started, but then stopped (e.g., it ran out of fuel)

Press the <DOWN> soft key to proceed.

The 24 hr vs time screen counts down the minutes, starting at 1440, of the 24-hour voltage start set point. After the battery voltage has fallen below its 24-hour set point, the timer starts and is displayed here. Pressing the <DOWN> soft key brings up the 2hr vs time screen.

The 2hr vs time 120 min screen counts down the 2-hour voltage start set point. Pressing the <DOWN> soft key leads to the2 min vs time screen.

The 2 min vs time screen counts down the

2-minute voltage start set point. Pressing the <DOWN> soft key leads to thelsstart timer screen.

86