Cooper Lighting PP Exploded assembly, PS Exploded assembly, Small, INDOOR CPP/CPS

Installation Instructions

Sheet 2 of 5

Vault w/ visor C-Scroll w/ visor Roundel w/ visor

These installation instructions are valid with the above Ametrix styles.

Small, INDOOR

CPP/CPS

(Continuous Pendant)

Visor and Non-Visor

Warning: Before starting any work ensure that all sources of power are turned off. All work must meet local/national codes and be performed by a certified electrician. Do not mount fixtures vertically.

PP Exploded assembly

PS Exploded assembly

#8-32 x1/2" Screw (2x)

Pendant yoke

#10-32 x5/8" End Screw

PP mounting plate

PP canopy

Pendant nut

#8-32 x1/2"	PS mounting
	plate
Screw
(2x)
	PS canopy
Pendant yoke
	Pendant
#10-32 x5/8"	nut
End screw

1.Secure pendant yoke to pendant tube using both pendant nuts prior to installation.

1.Secure pendant yoke to pendant tube using both pendant nuts prior to installation.

1Mounting power-side pendant to J-box

2Mounting non power side pendant

J-box

(by others)

PS mounting plate

Run wiring into pendant tube

#8-32 x1/2" Screw (2x)

Canopy

PS mounting plate

#8-32 x1/2" Screw (2x)

Canopy

These instructions are valid for both PP and PS mounting assemblies. Secure both pendant assemblies to ceiling before attaching fixture head.

1.Remove canopy and allow it to slide down pendant.

2.Refer to power orientation supplementary sheet for power location.

3.Run wiring from j-box down pendant tube and using #8-32 x1/2" Pan head screws, secure mounting plate to j-box. Reinforce J-box with additional bracing.

These instructions are valid for both PP and PS mounting assemblies

1.To secure non-power pendant, remove canopy and allow it to slide down pendant.

2.Replace #8 Pan head screws with appropriate fasteners(by others) Use additional bracing to secure pendant.

3.Secure mounting plate on center using dimensions provided on next page.

ADY071477 REV A (ECN080352)