PORTFOLIO
Figure 4 |
|
| TO INSTALL LOWER REFLECTOR ASSEMBLY | |
|
| STEP 3: Attach safety tether from lower reflector assembly to mounting bracket inside the can via clip. | ||
|
|
| Reflector Assembly is held in place with torsion springs that pass through slots inside the can. (Figure 5) | |
|
|
| ||
|
|
| WALL MOUNT ONLY | |
|
|
| ||
|
|
| STEP 4: Install wall housing/wall bracket shown in Figure 6 over the outlet box on the wall. | |
|
|
| ||
|
| |||
|
|
| STEP 5: Using the (2) screws shown in Figure 5, secure the assembly to the outlet box. | |
|
|
| STEP 6: Make wiring connections. | |
|
|
| STEP 7: Follow steps | |
|
|
| RELAMPING: Allow sufficient time for the lamp to cool. Relamping can be performed from below the | |
|
|
| fixture. | |
|
|
|
| To relamp from below the fixture: Remove lower trim and then remove |
|
|
|
| upper reflector by pressing the four retention springs inward (Figure 7). |
|
|
|
| Rotate heat sink to clear retention springs and carefully separate from |
|
|
|
| reflector assembly. Replace lamp and reassemble as described in steps |
Figure 5 |
|
|
| |
|
|
|
| CLEANING: First, gently wipe with a soft, clean, dry |
|
|
|
| remove loose dust. Then, use mild detergent solution on a soft cloth to |
|
|
|
| remove finger prints and stains. Rinse with clean, soft water and dry with |
|
|
|
|
Figure 6
For Clarity, Housing
Can is not shown
Screws
Hole that |
|
safety tether | Slots that Torsion |
clips | Spring Hooks into |
Wall Bracket
Clip |
| Screws |
|
| |
Safety |
| WALL MOUNT ONLY |
Tether |
| |
| Torsion | Figure 7 |
| Springs | |
| Depress these 4 retention springs | |
|
| |
|
| to install/remove the upper trim. |
Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 | 12/18/06 | 704244 |