INSTALLATION INSTRUCTIONS
IMPORTANT: READ CAREFULLY BEFORE INSTALLING FIXTURE.
Talon Large
Sheet 3 of 3
7/23/08IMI-682SW
WARNING: Risk of Fire/Electric Shock. If not qualified, consult an electrician.
WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing or servicing.
WARNING: Risk of Burn. Disconnect power and allow fixture to cool before changing bulb or handling fixture.
WARNING: Risk of Personal Injury. Fixture may become damaged and/or unstable if not installed properly. Tighten all fixture components to their recommended torque values.
WARNING: Risk of Fire/Electrical Shock. Upside down installation can result in overheating or accumulation of water in fixture. Install right side up.
2.Remove the
3. Assure that the thumbscrews on the powertray and both latches on the door are fastened securely.
OPTIC DISTRIBUTION AND ORIENTATION | ||
The Talon Large fixture is offered with some optics that have | ||
| ||
directional distributions. For aiming purposes, the Talon Large was | FIG. 6 | |
designed with the flexibility to allow each of its optics to be rotated |
| |
to any of four (4) positions, located at 90° increments. There are | Thumbscrews | |
two (2) mounting configurations that are used to mount all of the |
| |
Talon Large optics. The |
| |
Type 4 vertical optic) use the horizontal optics adapter. All vertically |
| |
lamped optics use the vertical mount adapter. |
|
1.Vertical Optics: Open the door and remove the lamp. Use a screwdriver to slightly loosen (do not remove) the four (4) screws
as shown in FIG. 7. The optic has four (4) keyhole details that | Remove Optic, Rotate |
To Desired Position | |
allow it to release by turning the reflector clockwise a few | And Fasten Into Place |
| |
degrees allowing the optic to be removed. Reposition the optic |
|
and tighten the screws securely. | FIG. 7 |
2. Horizontal Optics: (this also covers the Type 4 vertical optic). |
| |
Open the door and remove the lamp. Use a screwdriver to |
| |
remove the four (4) screws as shown in FIG. 8. Reposition the | FIG. 8 | |
optic and reinsert the screws securely. | ||
|
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user's purpose, please contact your nearest representative.
Remove Optic, Rotate
To Desired Position
And Fasten Into Place
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.
NOTE: Specifications and dimensions subject to change without notice.
Visit our web site at www.cooperlighting.com
Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 770.486.4800 FAX 770.486.4801 ADW081603
