Cooper Lighting V90229-1N V90229-2, Lampholder, Avoid Fire or Electric Shock, Combolight

INSTALLATION INSTRUCTIONS

V90229-2		 		COMBOLIGHT
Avoid Fire or Electric Shock			
		R		LAMPHOLDER
				Page 2 of 3

*Installation Instructions for qualified electricians only. *Install per National Electrical Code and local regulations. *Read Installation Instructions completely before installation. *Failure to follow Installation Instructions may void warranties.

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

11.Lamp installation:

To install LAMP, remove the COVER RING by pushing straight back on the COVER RING and then turning it counter-clockwiseto release. See Fig. 5.

12.Once removed, insert the properly-specified LAMP into the

BACK RING, ensure that the LAMP is the correct LAMP for the SOCKET or damage to the fixture or lamp may occur. The LAMP will seat into the COIL SPRING when installed properly. While holding the LAMP in place, grab the SOCKET ASSY and plug or screw the LAMP firmly into it.

See Fig. 6.

BACK RING

COVER

RING

COIL SPRING

Figure 5

SOCKET ASSY

BACK RING

PIVOT JOINT (FOR GIMBAL TIGHTENING)

LAMP

(MR16 shown, COIL SPRING behind)

Figure 6

(Cover Ring Removed)

OPTICAL

ACCESSORY

ACCESSORY

RETAINER

RING

COVER

RING

Figure 7

13.Optical Accessory: (skip to Step 21 if not using optical accessories) To install OPTICAL ACCESSORY pieces, remove the ACCESSORY RETAINER RING by unthreading until it is completely removed from the

COVER RING.

14.Install desired OPTICAL ACCESSORY pieces into the COVER RING and re-thread the ACCESSORY RETAINER RING firmly. See Fig. 7.

*The COVER RING can accommodate three (3) accessories without the ACCESSORY RETAINER RING or two (2) pieces with it.

*The ACCESSORY RETAINER RING may be used to lock the accessory. For example, a linear spread lens or cross baffle can be locked in-place into a desired orientation.

*Please note that not all accessories are compatible with each other and with all lamps.

CEILING

LINE

	SNOOT
Flush Position	Regressed Position

Figure 8

15.Regressed Lamp Ring/Snoot: (skip to Step 19 if not regressing the lamp) The lamp ring may be installed in a regressed position only if a

SNOOT accessory is being used. See Fig. 8. If necessary, please see step 13 for instructions on SNOOT installation. To accomplish the regressed lamp ring position set the COVER RING aside. Remove the lamp ring assy by loosening the two (2) SET SCREWs in the GIMBAL BLOCKs.

16.Once loosened the lamp ring assy can be removed by grasping the GIMBAL RING and turning clockwise until it releases from the GIMBAL BLOCKs.