Thermostat Reset Upgrade Kit Installation Instructions
8.Place hole template at lower left of back of frame. The dot sticker should be at the lower left of template. Line up edge of hole template to edge of frame, as shown, and clamp in place.
Template | Clamp in place. |
|
Start Holes
Dot sticker in
lower left.
9.Start 4 smaller holes with the drill using the 1/8” bit through template and into frame. DO NOT DRILL THE ENTIRE HOLE, ONLY START HOLE TO MARK LOCATION! If preferred, use a center punch to mark hole locations.
10.Unclamp the template and place just inside frame, as shown. The template MUST BE between the frame and hoses to prevent hose puncture. Be sure that large hole in template is in position well above the holes being drilled
Place template, as shown, between frame and hoses.
11.Drill the two small holes near the left side. Move the template, as shown, when finished drilling making sure it is between the frame and hoses, with the large template hole away from the right side holes. Drill the 2 smaller holes on the right.
Place template in this position when drilling large hole.
12.File down any burrs on all 4 holes, carefully clean up all metal shavings.
13.Place Snap Bushing in the 7/8” hole. Feed the main power and contactor harnesses through the hole.
Publication Number: 629088480INS | - 4 - | © 2005, IMI Cornelius Inc. |
